The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


Back to Member

Go to Thread

Member Picture

R22RumRunner at aol.com



progress/bad advice

2008-07-16; 08:39:15 EDT

Member Since

2002-09-17

Posts: 4946

Art,
Not good advice. A replacement car is readily available from GB. I wouldn't  
use anything but an original replacement and certainly not a machine screw.  
Being able to drop the boom is one of the easiest ways to adjust the rigging 
for  big winds. However, some of our Rhodies obviously have enough mass that 
they  don't have a need to lower the center of effort on their boat. :)
 
Rummy
 
 
In a message dated 7/16/2008 7:44:55 A.M. Eastern Daylight Time,  
czerwonky at earthlink.net writes:

Tom,
I wouldn't lose sleep over the archives issue.  Our  Rhoadie skippers, with 
just a few exceptions, have enough patience with our  fleet colleagues to 
address specific questions like this, even given that many  are repeated.  Your 
picture says it all - you can see both pins are the  same - Stan will probably 
not have a replacement, but can tell you where he  gets the assembled 'car'.  In 
the interim, the boom will have to be moved  up or down infrequently - I have 
never had to put mine into the lower position  - use a #6 machine screw (or 
one with reasonable fit, including length) from  HD to hold it in either 
position, until you can replace the pin.  Stan  may be able to send you a 
replacement car for a  cost.
R,
Art

See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting