The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


Back to Member

Go to Thread

Member Picture

R22RumRunner at aol.com



Pop top slider on IMF mast

2012-06-01; 11:18:06 EDT

Member Since

2002-09-17

Posts: 4946

Rob,
S C R E W E D. Time to take a do over. Been there, done that.....more than  
once.
 
Rummy
 
 
In a message dated 6/1/2012 9:34:57 A.M. Eastern Daylight Time,  
rlowe at vt.edu writes:

Yeah, I  was hoping to avoid that.  But might have to.

Thought about  releasing all stays and shrouds except rears and forward and 
seeing if could  tilt mast forward enough to slid it in.  Don't think I can 
get enough  angle on it.
Thought about doing above and using a pry bar on the mast step  under the 
mast and lifting up the whole thing a couple of inches.
Thought  about enlarging the existing slot big enough to accept the slider. 
 Would  do this at the very base of the mast where the structural integrity 
would not  be compromised.  At this point the mast is resting on the base.  
 

Any other thoughts?  Or just suck it up and drop the mast? -  rob

See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting