Not exactly screws. More like bolts with nuts and washers. Thousands of  
them (Just seems that way) The electric screw gun is a great recommendation.  
What I'm seeing is a very new cap gasket. The EPDM is still very black  
unlike the whitening of an older material. You might get by with just going  
around and making sure all the bolts are snug. Stan doesn't recommend, nor use  
any sealer on his installations.
 
Rummy
 
 
In a message dated 7/30/2012 10:23:19 P.M. Eastern Daylight Time,  
bobandkathyr22 at bellsouth.net writes:

David:  Your presumption is correct.  It is not a  difficult job but a bit 
time consuming.  Remove as much "stuff" as you  can so that you don't find 
yourself doing double duty.   Lots of  screws so have a container or two to 
put them in with some labeling.  An  electric screw driver will simplify the 
job.


Bob on the "NoKaOi  03"

________________________________
From: David Craft  <chsyhkr at gmail.com>
To: Rhodes List  <rhodes22-list at rhodes22.org> 
Sent: Monday, July 30, 2012 5:01  PM
Subject: [Rhodes22-list] Bilge and centerboard access

Last post  for today.

Here is a shot of our bilge.  You can see the top of  the centerboard
access.  I presume we have to dissassemble the step  into the cabin and
drawer below if you wan to access this fully to replace  the line to raise
and lower the centerboard......

This might be  helpful to others.......

David Craft
89 Recycled 08
Coastal  NC
__________________________________________________
To  subscribe/unsubscribe go to  
http://www.rhodes22.org/mailman/listinfo/rhodes22-list

For the list  Charter and help with using the mailing list and archives go 
to  http://www.rhodes22.org/list
__________________________________________________
__________________________________________________
To  subscribe/unsubscribe go to  
http://www.rhodes22.org/mailman/listinfo/rhodes22-list

For the list  Charter and help with using the mailing list and archives go 
to  http://www.rhodes22.org/list
__________________________________________________