The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

joedempsey



Crack in Transom

2019-06-28; 10:24:03 EDT

Member Since

2016-12-14

Posts: 257

Jim,
I've just had the same problem. I don't know the cause but here's how I
fixed it:Raise motor, if still on lift to point where it begins to tilt to
take pressure off of the plate.  Remove the lower phillips screw in the
guide plate and swing plate to left. My Rhodes has plywood reinforcing on
the inside so I couldn't get to both sides. I didn't need fiberglass mat,
just a West Epoxy System repair kit. Grind out rough edges of crack and sand
surrounding area with 60 grit paper. Mix epoxy and with the syringe, force
epoxy into the damaged area. Add thickener to the remaining epoxy to a past
consistency and spread into the damaged area. I'm surprised that there is no
reinforcement on the inside of your lazarette! "Respite" was recycled in
2005. My guess is that the motor lift was added at that time. I still need
to get some dark blue epoxy paint. Any suggestions from the List?

I don't know what caused the damage, but suspect the guides that follow in
the metal tracks are shot. Hopefully, it will last through the season. I'd
appreciate any evaluation or comments on my repair process. My first venture
into hull repair.

Transom_Damage.jpg
Transom_Damage_Sanded.jpg
Transom_Damage_Epoxied.jpg




-----
JP Dempsey
s/v Respite 
Rhodes 22 1989/2005
Marshall,VA
--
Sent from: http://rhodes-22.1065344.n5.nabble.com/
See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting