The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

ksimolo



GB roller furling jib

2019-07-05; 13:53:56 EDT

Member Since

2019-07-04

Posts: 13

Hi Bob,

I did not see any pictures attached so it is hard for me to tell what is
going on.  Without seeing it, I can not say if a longer screw will start
getting too close to the wire.  If it looks like that might be an issue, I
would try for the next larger size.  Be careful if you have to drill the
hole larger - go in small steps in drill size doing a test fit each time so
as to not end up having a loose screw again.

Are you keeping tension on the sheet as you furl the jib and visa versa as
you unfurl?

Ken







-----
1988 Rhodes 22 refurbed in 2008
--
Sent from: http://rhodes-22.1065344.n5.nabble.com/
See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting