2019-07-26; 23:56:10 EDT
Member Since
2019-06-20
Posts: 100
As I posted a few days ago, I’ve just bought a beautiful 1986 Rhodes refurbed in 2010. I’ve spent very little time on the boat and don’t pick it up until this Monday. The boat has many neat features including the electric motor lift. I may be unnecessarily worrying about this, but I worry about a 2500 lb pull winch not stopping when it should while raising the motor, either through a malfunction or some stupid mistake I or someone else might make. I’ve been playing with an idea I’d like to post and get some feedback from others who may have thought about this and anyone who knows more about diodes than the very limited knowledge I have. I hope my PDF will show up on this post. Since I didn’t have the boat in front of me when I started designing this, I have no idea if it is feasible. Basically I envision the motor coming up and when it is the proper height, some part of the motor or lift system pushes a lever when extends through the transom into the lazarette. (a small hole would need to be drilled through the transom, perhaps with some sort of rubber boot to semi seal the opening) This lever pushes on a spring loaded rod and breaks the circuit for the up current stopping the lift motor. The diode would prevent any current flowing to the up side when the circuit is broken, but would allow the reverse current to lower the motor. The diode and contacts would be enclosed in some sort of plastic electrical box. One question I have for those with electrical knowledge is what diode would I use for a 12V 30 amp circuit? Thanks for looking at this crazy idea, George Morgan Lift_cutout.pdf Lift_cutout.pdf -- Sent from: http://rhodes-22.1065344.n5.nabble.com/See the original archive post