2019-07-29; 22:49:50 EDT
Member Since
2019-06-04
Posts: 463
Thanks for the quick feedback! I should have posted with better photographs last night, but I was worn out after an eventful first weekend with the boat. Sorry the light isn't the best in the photos from tonight, but I wasn't able to get to the boat until a bit before sunset. A caveat regarding the photos from tonight is that the boat is not perfectly level as it is parked on the trailer since the pavement is on a slight incline. The photos of the boat in the water are from the weekend. The next time I'll be able to get it in the water is Sunday. Here are some notes in reply to the feedback in posts from the group: 1) Background about the boat: it is a 1991 model that was refurbished in 2013. The prior owner is very helpful, but he is traveling out of the country at the moment so I turned to the list for advice instead. 2) The main is a Doyle sail, apparently made for the Rhodes 22, that was installed by the prior owner a few years ago. 3) I took off the topping lift while under sail and reattached it just before furling the main. I didn't realize that it is best to leave it on during light wind. 3) Some photos of the roller furling drum are attached. Should I simply take out the pin and turn clockwise to shorten the forestay? Also, do I need to unscrew the black plastic guide for the furling line or simply move the line out the way and the guide would rotate as well. Since it was a bit late when I got to the boat today I didn't experiment with this yet. Also I assume that I may need to release tension on the lower aft stays before tightening the forestay. 4) To get to the tension of 300 lb for the upper side stays and 200 lb for the lower side stays, I simply tightened the turn buckles by hand though it took some effort to reach that tension. Is this too much tension? 5) The boom is at the standard height with the gooseneck set at the height which allows for sailing with the pop top up. 6) If I'm reading the diagram from Richard and the example photos showing the back stay tensioner on other Rhodes, it appears that mine is set appropriately with the double purchase. Please correct me if I am mistaken. Thanks in advance for your help! StarboardViewAtDock.jpg StarboardBowViewAtDock.jpg UnderSail.jpg BackStayUnderTensionWithBoom.jpg BackStayUnderTensionWithBoomZoom1.jpg nsionWithBoomZoom2.jpg nsionWithBoomZoom3.jpg nsionWithBoomRearView.jpg JibFurler1.jpg JibFurler2.jpg JibFurler3.jpg -- Sent from: http://rhodes-22.1065344.n5.nabble.com/See the original archive post