Hi:
If the boom clears the back stays, then hardware similar to that in this
photo may help. Sweet Baboo's boom clearance from back stays across the
arc is 1.5 to 2 in).
Cheers,
Shawn
s/v Sweet Baboo
20190731_194424.jpg
On Thu, Aug 1, 2019, 4:23 PM S/V Lark <Colealexander at hotmail.com> wrote:
> I forgot my tape measure Wednesday, but by eyeball the space between the
> pop
> top and gooseneck slides look similar. The mast looks fairly straight,
> but hanging a plumb bob from the lift when the boat is trim so the boot
> stripe is even might help confirm that. On my boat the boom lift is left
> tied to the stainless eyestrap. I never disconnect it, it does chafe the
> mainsail on the run down from the masthead at times, if run to the block in
> the port deckhouse and aft to the cockpit cleat. If cruising I might use
> the mast cleat like I would with the pop top tent. For day sailing I tack
> so often I doubt it will damage the sail, and I often adjust boom height
> for
> weather and passengers. Eliminating the shackle and using the bent strap
> for the lift might gain half an inch. I have about a fist clearance
> between my boom and the backstays. One obvious question, have you checked
> the length of your boom extrusion? At full extension there is about a
> fist
> of outhaul at the clew on my boat.
>> Good luck with this frustrating problem. If nobody beats me I’ll measure
> the Lark next time.
>> Regarding tension, I don’t think you will flex the hull much like you might
> on other designs of this vintage, but you cannot ask the rig to perform
> like
> a high performance racing machine either. I doubt mine is 200 pounds,
> but
> never checked. Maybe it is??. I tighten as much as I can and retighten
> after a couple sails in stiff wind. I tighten the backstay line every
> couple weeks, especially before going out in wind.
>> Alex
>>>>>> -----
> Alex Cole
> S/V Lark
> --
> Sent from: http://rhodes-22.1065344.n5.nabble.com/>
×
Message to Webmaster:
To use your email application to send a messsage to the webmaster rather than this form,
.