2019-09-23; 16:46:31 EDT
Member Since
2016-04-25
Posts: 206
Stan. Wow. I managed to crack the black plastic rudder cheek (port side) yesterday at the bottom bolt. In my defense, yes the rudder was down all the way as instructed. It was windy. Predicted 10-20 but at the time it was 20 sustained, with gusts to 30 and 70 degree shifts (I looked it up). I was close hauled on a port tack but heavily reefed. The main was out to one "2" and the jib to the height of the lower "22". I had just been crossed by a windsurfer which went down in a shift / gust and was blowing toward me. Of course he was off my port bow and the boat wanted to round up. I released the sheets, but the boat and I were arguing about the merits of a new bowsprit. Since it wasn't a pretty girl I insisted we fall off. I finally got the LARK to agree, but heard a pop. Anyway, I would like to buy another port side plastic cheek and if you have them, the stainless lock nuts plus one grommet (twisted when it cracked). Am I just hard on equipment? Since I'm at it, I also had a stress crack of the starboard black plastic part that holds the companionway hatch in place. The bottom cracked off at the bottom screw. I have no idea why, nobody had tried to break in. I made replacements for both sides from some Mahogany I had bought years ago for the other boat but when I opened the shrink wrap I found it was some African knock off that is very light weight and may or may not be rot resistant. While I'm at it, I may as well ask for another factory original. I make somebody else do my website proof reading. You can post your edits here and let the group pick them apart. Alex Colealexander at Hotmail.com cell 260 five 78 0178 office 937 six 53 7326 ----- Alex Cole S/V Lark -- Sent from: http://rhodes-22.1065344.n5.nabble.com/See the original archive post