On Fri, Oct 18, 2019 at 11:16 PM Gmorganflier <gmorgan.flier at gmail.com>
wrote:
> I’ve been going through the archives looking at all the interesting things
> Rhodes discuss. I know there have been discussions about how to deploy an
> anchor from the cockpit. I don’t recall reading about the idea below, so I
> thought I’d share it.
> There is a drawing which gos with the article which I will try to attach.
>> George
> S/V Knotty Lady
>> ___________________________________________________________
>>> The Javit Anchor System
>> One of our readers sent us an interesting idea on how to handle your anchor
> particularly if you are single handing your boat or have kids on board.
>> Mark Javit explained that his father Lewis developed this idea for several
> reasons. He often went out either by himself or with his small kids and
> didn't want to risk anyone falling overboard to set the anchor. He also
> didn't want to scuff the fine mahogany finish on his foredeck. Lewis like
> to fish and he like the mahogany.
>> This is what Lewis Javit came up with.
>> 62435511-75BE-45D8-8F17-DAD7664C131D.jpeg
> <
>http://rhodes-22.1065344.n5.nabble.com/file/t909/62435511-75BE-45D8-8F17-DAD7664C131D.jpeg>
>>> This picture shows the rode in mid-deployment or mid-retrieval. It is
> important to fully deploy the anchor rode so your vessel is properly
> anchored and secured in the proper orientation.
> The Setup
>> The anchor is stowed in one of the cockpit lockers with the rode attached.
> The rode is run from the anchor to the bow and firmly attached there. The
> remainder of the rode is kept with the anchor in the locker.
>> Now here's the tricky part. A tag line (shown in red) is attached to the
> rode via a pulley which allows the rode to easily slip along the end of the
> tag line. The tag line is long enough to reach from the stern to the bow
> with a little extra to tie off to the stern and to remain slack when
> deployed.
>> Deploying the Anchor
>> You simply drop the anchor overboard from the cockpit and allow the rode to
> pay out until it begins to snug against the tag line. You then let the tag
> line pay out until the pulley reaches the bow, give it a little extra slack
> and then cleat off the cockpit end of the tag.
>> Retrieving the Anchor
>> To retrieve the anchor pull the tag line back into the cockpit until you
> can
> reach the anchor rode. Grab onto the rode and pull it back into the boat
> until the anchor is retrieved.
>>>>> --
> Sent from: http://rhodes-22.1065344.n5.nabble.com/>
×
Message to Webmaster:
To use your email application to send a messsage to the webmaster rather than this form,
.