The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Allyn Baskerville



Unsure how to remove “hose” for centerboard line

2019-11-08; 19:17:45 EST

Member Since

2019-10-20

Posts: 78

I attached a photo to the email, but I guess the server stripped it off. Here is a link to what I sent:

https://1drv.ms/u/s!ApL2Pe-LKYIig0cINC3Nisn4lETt?e=9jRb5h

As I said, there are two layers of tubes, and these are *very* stiff. I've raised the tube as high as it can go, so when I raise it further, the fiberglass cabin threshold raises up. I'm concerned about breaking fiberglass past this point. Goodness, I'll grab some of the cheap hose and give that a shot - I'll simply cut the old tube off with a knife.

** I do have one question - there is a clamp at the top of the tube, and it is surrounded by fiberglass. There is no way of getting a screwdriver or nut driver in there apart from cutting out more fiberglass as far as I can tell. Is there any other option?

It's rained a lot this week. I drained 10 gallons out of the boat last week, and I'd say there is at least another gallon in it. I have 4 tubes of the 3M 4200 sealant - maybe I can get some of this resolved over the weekend.
See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting