2019-11-09; 20:50:27 EST
Member Since
2019-06-04
Posts: 463
Since this post generated some interest (thanks for all the input), here is an update: During the sailing season, I drilled a new hole a little over halfway between the lower and upper mast setting, which you can see with the green arrow in the first attached photo. This eliminated the clearance issues with the backstay. 20190918_193949_LI.jpg At this setting the pop top had to be down and I added a boom vang which you can see on the next photo. 20190817_184227.jpg Now that my boat is off the water for the winter, I went ahead and shortened my boom by 3.25". Without the cap, that leaves 119.75" for the extrusion and with the cap, it comes out to 120-1/8". This does not count the gooseneck hardware. Before I cut the boom, I had 6.5" of excess outhaul clearance (shown below) so now I'll be down to about half of that. I didn't want to go too far and regret it. In the photos below you can see it after shortening, along with the piece that I cut off. ShortenedBoom.jpg 20191109_130826.jpg My boom is still a bit longer than what was reported by others, but I should be able to leave it on the higher setting now without interfering with the backstays. In case anyone else finds themselves in this situation, here's the steps I took: - drilled out the rivets that hold the cap on - pried / tapped out the end cap - unscrewed the remaining hardware - removed the outhaul rope and slide out the outhaul car and hardware - used a miter saw with a metal cutting blade to cut off the excess length - mark the spot for a 3/4" hole for the outhaul rope to go through the boom - use a drill press, starting with a small bit and drilling progressively larger holes to get to 3/4" - inserted the end cap and used the drill press to dril new holes for rivets (I didn't try to match the old holes) - rivet on the end cap - drill new holes for the hardware on top and bottom of the hole for the outhaul, then screw this hardware in - put the outhaul and car back on Fortunately I was able to borrow a chop saw with a metal cutting blade as well as a drill press and bits so that made this job a lot better than if I was trying to use a hack saw and hand drill. I'm looking forward to sailing with the pop top up and the bimini overhead next season. -- Sent from: http://rhodes-22.1065344.n5.nabble.com/See the original archive post