The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

cjlowe at sssnet.com



masthead light - steaming vs. all around

2019-11-14; 22:02:16 EST

Member Since

2008-02-18

Posts: 319

I wouldn't recommend using the mast as a conductor for several reasons.
1. It gives a lighting strike instant access to all of your electronic and
electrical systems.
2. You have to drill and tap a hole in the mast to screw the terminal to.
The screw and terminal will start to oxidize from the contact of
dissimilar metals. The marine environment will greatly accelerate this
process.
3. If boat manufacturers could safely save 25 to 50 feet of wire on every
boat they build, they most likely would.
The idea of using the mast and the DPDT switch is like standing in water,
grabbing the bare wire and yelling OK turn it on.
Ok,I'm done being downer Debby, every thing else Mike said was spot on. I
would like to emphasize that you can control two lights with two wires,
BUT, you can only turn one on at a time. If your lights are not polarity
sensitive the DPDT SWITCH deal is off. Some led lights aren't designed
with switching polarity in mind, and aren't robust enough electronically
to survive this duty. Make sure before you buy. "It should work ", is not
the answer your looking for.
I'm on vacation right now, and the Browns are winning (right now) so more
on this later.

Jerry Lowe




For those who are considering how to increase function of the mast mounted
See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting