The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Graham Stewart



hatch on foredeck

2019-12-01; 19:31:31 EST

Member Since

2005-04-29

Posts: 816

The rub rails are not solid - as you can see in the attached photo - but the glass is probably thick enough to hold screws if they are installed properly. I my case I installed the chocks inboard of the rub rails where they were originally installed and could be bolted through the deck with fender washers and nuts on the inside. I don't trust screws for anything that takes a significant strain. However, I raised them up 1" on blocks of composite lumber so that the lines cleared the rub rails to avoid chafe and blemishes. 

The second photo shows where they were placed originally.

Graham

Graham Stewart
Agile 1976 Rhodes 22
Kingston Ontario




Deck reconstruction Aug 2011 (6).jpg

deck hardware (2).jpg
See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting