2019-12-03; 09:30:09 EST
Member Since
2005-04-29
Posts: 816
Jesse: Yes, I did some major restoration work which showed in part in the photo of the foredeck being removed. I literally cut the deck in front of the cabin roof and removed it. I then separated the liner, removed the core material, replaced the core with multiple layers of epoxy-coated marine plywood, and then reinstalled the deck. It might sound like a simple 4-step process but it took me all summer just to do that. Refinishing the boat was another big project. Had I know then what I know now I would have realized that all that was unnecessary. I thought that the core was in very poor condition as I knew there had been a water leak into the core, the deck was very soft when I stood on I, and I had a nest of flying ants above the liner that I assumed was an indication of severe core damage. At the time was encouraged to be so adventurous because I thought that there was a very good chance that I would end up taking the boat to the dump as being unsalvageable. I was just curious to see what was happening between the deck skin and liner. As it turned out, there was very little damage to the core. The wet spot was relatively small with no sign of rot and there was no trace of damage from the flying ants. However, the core was made of regular indoor plywood that had dried out and delaminated from the deck and liner. It had only been attached with very little strands of sealant that in most areas hadn't even touched the skins. Hence it came apart and was removed mostly with my bare hands. The individual layers of the plywood had also separated. As a result the deck had lost virtually all of its rigidity. It would have been much, much, much less trouble and probably just as effective to have dried out the wet spot and then injected thickened epoxy into the entire core and between the core and the deck skin, but without being able to see what was happening I had no idea that epoxy injection would be effective. In fact, for the side decks I used this method of epoxy injection and got very good results. There are a few tricks to getting the epoxy into the right places and being able to see the core from the cut edge was essential to that process. I posted this work and my conclusions to the list so that all those contemplating the removal of their deck might avoid a lot of work. As it turned out there were not a lot of people contemplating doing that. However, It I think it might have been useful to some to be able to see what I discovered inside the deck. Getting the deck pack on and aligned turned out to be a very difficult process - for a complete novice like me. I had made a frame to hold the foredeck in its original shape while I replaced the core but, while it helped, it didn't work very well and the new deck did not align well with the rest of the boat. (The deck is much less symmetrical than I had expected it to be.) So fitting it back on the boat was very time-consuming and required a LOT of fairing and reinforcement. In the end, however, the surgery is not visible either on the inside or outside and I have a foredeck that could puncture a concrete wall. To finish the deck I had to grind off all of the non-skid gel coat on the foredeck and side decks, apply several layers of glass and endless fairing to the entire area, paint the entire deck and cockpit, and apply a new nonskid. All in all a ridiculous amount of work. It took about four years of summer work just to this repair - although I was doing a plethora of other repairs as well. The total restoration took seven years. I note that somewhere along the line Stan stopped using plywood as the core material for the R22 and as a result the problems I had would be avoided. My advice to anyone purchasing an older R22 would be to determine what the core material is before the purchase. Graham Stewart Agile 1976 Rhodes 22 Kingston OntarioSee the original archive post