2019-12-04; 12:35:48 EST
Member Since
2005-04-29
Posts: 816
Rob: I don't think it is feasible to remove the liner in the cabin. Mine is bonded solidly to the core. I wasn't even able to pull out the existing cabin light wires as they were also bonded in. Even if to managed to remove the liner, getting it bak in place would be a devil of a job. I got around the problem by putting my electrical panel on the main bulkhead and running wires to the back inside the side bunk lockers, under the floor boards, and up to the panel tucked behind the compression post. One other advantage to having the panel on the bulkhead is that you have easy access to the back of the panel - where I seem to spend an inexplicable amount of time. I put my single battery aft of the Vbirth and ran the heavy cables under the floor boards. That way the weight is forward, access is easy and the length of the cables are relatively short. If running wires behind the liner is necessary, then I think you might be forced to cut a channel for the wires and then fill it in or cover the channel. I found a pure white filling compound that I used to patch seams and holes in my liner beautifully. I didn't even need to touch up with gel coat or paint. Although the surface is not gloss you really don't notice the difference unless you really look for it. It might also be possible to polish the surface to a gloss finish but I didn't think that was necessary. I can't remember the name of the stuff but if you are interested I can look it up. Of course I have to keep reminding myself and others that newer boats might be different and allow for wires to be fished through behind the liner. Graham Stewart Agile 1976 Rhodes 22 Kingston Ontario Interior final June 2018 (2).jpg Holding tank installation (5).jpgSee the original archive post