2019-12-04; 15:21:16 EST
Member Since
2016-04-14
Posts: 713
I agree with Graham that removing the liner isn’t a practical solution. On my boat GB ran the wires for the mast from the electrical panel above the galley counter-top, down along the hull behind the icebox, under the cabinet base, then forward through a hole at the bottom of the bulkhead under the head floor, then up a chase along side the compression post. From the top of the compression post, the wires are exposed for a few inches before running into a hole in the overhead just forward of the mast. The boat has a semi-enclosed head layout. Peter Nyberg Coventry, CT s/v Silverheels (1988/2016)See the original archive post