The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

ROGER PIHLAJA



Trailering with outboard

2019-12-06; 16:04:51 EST

Member Since

2002-08-01

Posts: 1438

Graham,

You’re welcome.  I have 25+ years and many thousands of trailering miles on my anti sway damper.  I actually wore the friction material out in my 1st unit and am now on my 2nd one.  You get a loud scraping sound like worn out disk brake pads when you turn or the trailer sways when its time to replace the anti sway damper.  They are not rebuildable.  But, the cost of a new unit is so low that buying a new one is not much of an issue.  The ball joints on each end of the damper don’t seem to wear out.

My ball joints and the associated brackets are welded on.  25 years ago, when I 1st installed the anti sway damper, welding was the only option.  But, I see new units can be bolted on.  My trailer tongue needed a special bracket in order to provide clearance for the trailer’s surge brake master cylinder.  Assuming you have this work done by a welding shop, you will still have only ~$125 sunk into the installation. That’s pretty cheap trailering insurance!

Roger Pihlaja
S/V Dynamic Equilibrium

Sent from Mail<https://go.microsoft.com/fwlink/?LinkId=550986> for Windows 10

From: Graham Stewart<mailto:gstewart8 at cogeco.ca>
Sent: Friday, December 6, 2019 3:03 PM
To: 'The Rhodes 22 Email List'<mailto:rhodes22-list at rhodes22.org>
Subject: Re: [Rhodes22-list] Trailering with outboard

Roger: That is very helpful feedback on the anti-sway device. I always wondered about those things. I think they would be well worth the modest price.
Graham

See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting