The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Graham Stewart



placing the boat on trailer

2019-12-07; 11:44:34 EST

Member Since

2005-04-29

Posts: 816

Roger says that placing the boat in the correct location "is an adjustment you do once". I can adjust the bow bracket into what would seem to be the correct position but have had a devil of a time actually placing the boat that far forward. While the boat is still in the water I can draw the bow into the bracket but as the boat is drawn out of the water and the stern lowers onto the bunk there is enormous pressure exerted onto the hull at the forward end of the bunks and as soon as the winch is released the bow springs up and away from the bracket. 
 
When I stripped the bottom of paint I found a mass of hairline cracks and permanent depressions on either side of the hull where the front posts of the bunks are located. That didn't seem right to me and now that it has been repaired I am reluctant to risk damaging the hull again.
 
I only tow my boat a few miles to the ramp and back going a low speed so I don't worry about getting the boat forward but if I were to take it on a longer trip at highway speeds I would be much more concerned to get the boat properly balanced on the trailer.
 
Others have mentioned the same problem and I am wondering if those who have solved this problem might give advice on how they balance the boat on the trailer.
 
Thanks,
 
Graham Stewart
Agile 1976 Rhodes 22
Kingston Ontario
 
 
 
See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting