The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Graham Stewart



A Special Full Moon

2019-12-13; 16:20:08 EST

Member Since

2005-04-29

Posts: 816

Jesse:
I redid the bottom of my boat a few years back and, so far as I can tell it
was the first complete strip and repair in its 40 year life. It can be a big
and unpleasant task if you have osmotic blistering. I did. I used MANY
layers of paint stripper for boats and a scraper to remove the old paint. I
really didn't want to sand the old antifouling paint because the dust is so
toxic. Even so, you want to protect the ground and you so that you can clean
the site thoroughly afterwards. 

Once the paint is mostly removed any osmotic blistering will become very
obvious as the tops of the bumps will come clean before the valleys between
them. I then used a dremmel with an abrasive drum to grind out all of the
disks down through the gel coat to the substrate - all 100 million of them.
Ok, that is an exaggeration but if the bottom is too bad it might be worth
having a professional soda blast the bottom to completely remove the gel
coat and then have the surface rebuilt by a professional - preferably in
epoxy. Once the bottom is stripped it needs to dry out thoroughly and that
can take months. It is best to strip it in the fall and let it dry all
winter. Once dry all of the blister holes need to be filled with epoxy
paste. There are a tone of YouTube videos and online instructions about this
part of the process and you would be well advised to take the time to become
familiar with the process.

Once the bottom is ready it is essential to give it a very thick epoxy
barrier coat. This is far more than a "sealer" coat. The two major options
are epoxy from a supplier like West system or use Interlux 2000E. Although I
have a lot of experience with West System epoxy I chose to go with the
Interlux 200E and I am glad I did. It is also an epoxy but also contains
tiny metal disks. It looks and goes on like paint easily with a roller. It
comes in white and grey. Get both and alternate the colors. Otherwise you
will miss areas very easily. I bought a gallon of each and used it all. I
think they recommend 5 coats but I applied 6 because I had the paint. As
soon as the coating tacks up you can apply another so over a day you can
apply at least three coats. No sanding is required between coats so long as
you apply each coat before the previous one cures. Applying the coating is
trivial compared to the work involved in preparing the bottom so I think it
would be insane to skip the barrier coat.

If your bottom has no osmosis consider yourself blessed. Even so I would
definitely adding an epoxy barrier coat. 

I have attached a few photos of the process.


Graham Stewart
Agile 1976 Rhodes 22
Kingston Ontario




Bottom showing blisters July 2014.jpg

Fairing completed August 2014.jpg

Osmosis repair Aug 2014.jpg

SafeStrip.jpg
See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting