2020-01-07; 22:33:51 EST
Member Since
2019-06-04
Posts: 463
I finally got back to this project and finished it. Here are some notes others may find helpful when installing a solar vent fan in the 3" hole for the anchor rode. Below decks when I screwed on the base of the fan, It didn't mount flush against the roof of the cabin, so it didn't put enough pressure to sufficiently compress the silicone gasket that I was using above the deck. To address this, I bought a 4" PVC pipe connector and cut off a 3/8" of that so that I had a 3/8" deep 4" diameter pipe. I cut this in half so I could fit it around and between the base of the fan and the roof the cabin. It was a two person job: one person to push down on the fan from above and compress the gasket, and another below to tap in the two pieces of PVC pipe that served as a giant washer. Now the fan is on nice and snug. Thanks goes to my brother for thinking of using the PVC pipe piece as a washer. I put sealant around the gasket which should keep the water out. On another thread (link below), I had posed the question about keeping the bow lines and anchor rode off the fan. The suggestion from Peter and others was to install chocks. http://rhodes-22.1065344.n5.nabble.com/hatch-on-foredeck-tp56302.html I ended up getting 6" chocks that had 3 holes each, since this would be more secure than smaller chocks with only two holes. I decided against installing them on the toe rail since Graham made the point that the toe rail is not solid fiberglass (appears to be similar in thickness to the rest of the deck) and even once I removed the wooden board that covers the edge of the deck in the forepeak, I couldn't easily access the underside of the toe rail. I got a 12"x12"x1/2" HPDE (also known as Starboard) from Amazon. I cut this into mounting blocks for the chocks. I doubled it up so there are two blocks under each chock (for a total depth of 1"). I went for the 1/2" HPDE since it was a lot cheaper than the 1" HPDE. https://www.amazon.com/gp/product/B000ILJZNY I sanded the edges of the tops of the blocks to be rounded so that ropes would not chafe against it. I also got thin steel plate at Ace Hardware and cut that into size for backing plates below decks. I painted those with Rustoleum before installation. Finally I used stainless 4" #10 screws with washers and lock nuts to bolt it all together, and bedded the chock blocks against the deck and the chock against the mounting blocks with silicone. 3.5" would have been ideal but I couldn't find that length. 3" was too short. I had to get the 4" screws on Amazon since I couldn't find them locally. I'll probably add some silicone caps on the end of the screws, and/or I might use a hacksaw to cut off excess length. https://www.amazon.com/gp/product/B07C69MV9S Side note: since purchasing the screws from Amazon, some other local sailors recommended a couple of other sources for hard to find hardware: www.boltdepot.com www.fastenal.com (there are also local locations Nationwide) Thanks to Graham and Peter especially for the tips on the installation for the chocks and block mounting suggestions. I'm satisfied with how it came out and it seems quite solid. Finished photos: FanAndChocks.jpg FanUpCloseOnTop.jpg ChocksUpClose.jpg ForepeakRoof.jpg -- Sent from: http://rhodes-22.1065344.n5.nabble.com/See the original archive post