2020-01-08; 07:33:38 EST
Member Since
2019-06-04
Posts: 463
Hi Graham, I think the cleat on the inside of the foredeck would be to tie off the bitter end of the anchor rode for safety if you were running the rode through the 3" hole on the foredeck. I suppose you could tie off again on the bowcleat on top for the appropriate length if you weren't using all the rode. The only use I personally have for the cleat is to grab onto when trying to shimmy into the forepeak to work on something. I think the cleat may have came installed from GB. Regarding the pipe that I used as a spacer, see the first photo below for a zoomed in view. I ran some caulk overtop of it to seal it in place (in addition to the pressure) so you can't actually see it underneath. Also below you can see a photo of a PVC coupling like I used. I drew in green around it roughly where I cut off the end to make a 3/8" deep pipe. There are also vertical green marks to show where I cut it into two pieces so I could fit it around the wide lip of the fitting at the base of the fan. I tapped in both sides under the deck but on top of the bottom fan fitting so the PVC pipe fits together again. I'm probably still not doing a good job of explaining this but hopefully this helps. SolarFanBottom.jpg PVCpipe.jpg -- Sent from: http://rhodes-22.1065344.n5.nabble.com/See the original archive post