2020-01-08; 22:12:47 EST
Member Since
2019-06-04
Posts: 463
On another thread about Chris's stowage for long term cruising, I mentioned the minor issue of some water coming back up through the cockpit drain. James had suggested installing a check valve. http://rhodes-22.1065344.n5.nabble.com/Long-term-cruising-stowage-tt56285.html Since I didn't want to add an external check valve that would require adding holes in the hull to screw in, I decided to install the inline check valve that James suggested, which was $10 at Amazon. It has a flapper that pushes down when water comes in from the top to allow it to go through, but the flapper is pushed up to seal and block when water comes from the bottom. https://www.amazon.com/gp/product/B07YSTX2SW/ The original connector hose was strongly attached, but was manageable to get off. It took a couple of tries to find connecting hoses that fit just right. I ended up using a different one for top and bottom: Top: Flexible Pvc Coupling with Stainless Steel Clamps 1 inch ($9) https://www.amazon.com/gp/product/B07GPXJ4HJ Bottom: 1 inch To 1.25 inches Straight Turbo/Intercooler/Intake Piping Coupler Reducer Silicone Hose ($5). This is built to withstand working pressure of 80 psi and burst pressure of 245 psi https://www.amazon.com/gp/product/B00GX0AFGA Steps: 1) Slide on the large side of the 1.25 couple onto the thru hull on the bottom 2) Slide on the flexible coupler to the drain from the cockpit. This will stretch to fit, but it take effort. *** MAKE SURE THE ARROW IS POINTING DOWN ON THE CHECK VALVE *** 3) Insert the check valve as far as it will go into the coupler on the bottom hose 4) Somehow wedge the top flexible coupler over the top of the check valve. At first this may seem impossible. A strong grip, some choice words, and grunting were enough to get this all connected in a straight line. 5) Secure with hose clamps. 6) I added quite a bit of tape over the bottom coupler to add strength since that is the portion that would be under pressure when the check valve is pushed shut by water coming up from the bottom. I used electrical tape and then I also added some Gorilla Waterproof Patch and Seal tape which is very adhesive and claims to be quite strong. 7) I added waterproof adhesive between the outside of the check valve and the inside of the drain pipe coming down from the cockpit so water doesn't seep down through the cracks. The check valve actually extends up into the hole coming down from the cockpit so the top connector isn't under pressure. Some considerations: - I'll have to make sure this doesn't get clogged - It has less throughput for draining then a straight hose which is a bit wider. My sailing locations are tame enough that I don't have to worry about following seas swamping the cockpit so I think I'll be OK. - I keep a soft foam cone shaped emergency boat plug in the lazarette in case I need to plug a thru hull quickly. I'm keeping the old hose in case I need to revert, but I think this will work out. I'll report back in the summer. In summary, with the right parts this turned out to be a cheap and simple project, but it requires some muscle to get the pieces in place. Here are some photos: 01Original.jpg 02BottomOn.jpg 03BottomAndTop.jpg 04WithTape.jpg 05FromTheTop.jpg -- Sent from: http://rhodes-22.1065344.n5.nabble.com/See the original archive post