The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

ROGER PIHLAJA



Shroud extenders

2020-04-16; 09:34:28 EDT

Member Since

2002-08-01

Posts: 1438

Jose,

My shroud extenders are made from aluminum bar stock 13” L x 1” W x 1/4” T.  Both ends are rounded off with 1/2” R arcs.  In other words, both ends look like a half circle.  Both ends have 3/8” ID holes drilled thru them.  The centers of these holes are located on the centerline and 1/2” from each end.  All of the sharp edges have been broken.  Hopefully, this answers your question.

Roger Pihlaja 
S/V Dynamic Equilibrium

Sent from my iPhone

See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting