The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Ric Stott



Swinging at anchor?

2020-05-03; 08:33:56 EDT

Member Since

2013-07-01

Posts: 437

I use my Bow eye for mooring and I can still reach it by kneeling on the bow and reaching under the pulpit. Hauling the boat last fall, I noticed the bow eye was loose and had about 3/4” of play. I crawled into the forepeak and found that the two nuts on the Stainless D ring were rusted  steel. The wood book had rotted at the washer and compressed 3/4”. I didn’t want to cut the eye off because I was unsure I could find the exact size replacement and did not want to epoxy the holes shut and re-drill them. So I crawled back into the bow with a Dremmel tool, surgically cut the nuts off and salvaged the Bow Eye. Stan told me his shop would never do use regular steel nuts, but obviously they did it more than once. 
And that’s just the beginning of my “Bad Haul Leads to  Centerboard Cap Rebuild” story.  If anyone is interested, I’ll take the time to document what not to do when hauling or launching a Rhodes 22 with an old style centerboard. 
Ric
sv Dadventure 
Hampton Bays. 



Sent from my iPhone

See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting