The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

ROGER PIHLAJA



Launch... and the story of an epic failure

2020-05-11; 09:46:00 EDT

Member Since

2002-08-01

Posts: 1438

Alexis,

What part of your bunks/support structure failed?  Did the metal bunk support poke right thru a rotten wooden bunk?  Or, did the metal bunk support structure fail somehow and leave a jagged shard to poke a hole thru your hull?  Anyway, your bunks and supports are all the same age.  So, it’s probably cheap insurance to go thru the whole system.

On a related note, are your bunks properly adjusted to uniformly cradle your hull?  If the bunks were configured to place too much weight on one bunk support; then, the failure mechanism would change from old age/wood rot/metal fatigue/rust to an overload scenario.  On my Lil Dude boat trailer, most of the weight of the boat sits on a couple of HD rollers that support the keel.  These keel rollers are bolted directly to the trailer.  The bunks on my trailer function more like “outriggers” to keep the boat from tipping over in a heavy crosswind or on a curve in the road.  They are not heavily loaded.  Does your trailer have keel rollers?  Are the keel rollers properly adjusted to take most of the boat’s weight?   If not, then the bunks are being overloaded and this might have something to do with the failure.  If your trailer does not have keel rollers; then, you might consider implementing them.  Properly adjusted keel rollers will dramatically reduce the load on your bunks, load the boat from the keel vs. the hull when it’s on the trailer, and should make launch/retrieval much easier.  The attached photo shows the bunks & keel rollers on S/V Dynamic Equilibrium’s trailer.  The photo also shows what properly adjusted bunks look like.  For retrieval, I usually submerge the trailer until only ~6-12” of the front of the bunks are exposed above the water.  For launching, I try to back the trailer in about the same amount.  But, if I can get the bunks submerged to about the 2nd bunk support from the stern, I can usually push the boat off the trailer because most of the weight is on the keel rollers, not the bunks.

Roger Pihlaja
S/V Dynamic Equilibrium

[cid:image003.jpg at 01D62778.F9E74390]

Sent from Mail<https://go.microsoft.com/fwlink/?LinkId=550986> for Windows 10

From: Alexis Seigneurin<mailto:alexis.seigneurin at gmail.com>
Sent: Sunday, May 10, 2020 8:31 PM
To: The Rhodes 22 Email List<mailto:rhodes22-list at rhodes22.org>
Subject: Re: [Rhodes22-list] Launch... and the story of an epic failure

Roger,

You’re right, I am very lucky the transom didn’t hit the ground!

I cannot tell for sure that the hull had been punctured during the first launch, but that is a possibility. That would explain why the boat was stuck at that time, for sure.

Regarding your question about the condition of the rest of the bunks, I would say the wood was looking like it would soon need to be replaced, but nothing alarming. I am going to replace all the bunks now, and also update the brake line as well as the electrical wires.

Yes, quite a few lessons learned, and quite a lot of work ahead of me!

Alexis



FE33BECB5C4A4E54945C7D4918421CA0.jpg
See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting