The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Mary Lou Troy



Emergency diamondboard help...at boatyard for only a little while longer

2020-05-24; 19:17:32 EDT

Member Since

2004-01-29

Posts: 1597

Hi Olivier,

The laminate is not standard R22 construction.

At one point we were going to do something to the board, I forget what, 
maybe replace the pennant or get rid of the pully in the raising system 
and had ordered a new gasket from Stan. When we got it apart and 
discovered the laminate, we abandoned the project. We asked Stan about 
it and via email he basically shrugged his shoulders and said something 
to the effect that "that wasn't our repair." It wasn't leaking, we found 
another way to do what we were going to do and forgot about it. In fact 
I didn't realize I still had the exchange with Stan in an old email 
program until now.

After a bit of back and forth on a photo, Stan's exact words on the 
subject from 2003 were:

"So what I am seeing is a fiberglass "washer" between the top lip of the 
trunk and
neoprene gasket.  The question then is was there any leakage between the 
fiberglass
gasket and the cb trunk lip?  If no then I would leave it in place and 
just use a
jib saw to cut on opening in it to match the opening in the cb trunk - 
it should
cut easily since it is probably not very thick  If on the other hand 
there was
leakage between this element and the cb trunk cap I would do whatever is 
necessary
to pull it off and throw it away and sand smooth the top of the trunk lip to
receive the neoprene gasket."

As I noted above, it wasn't leaking so my recollection is we decided not 
to mess with it.

Sorry this isn't more help.

Mary Lou


See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting