The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

ROGER PIHLAJA



Rudder Askew

2020-05-29; 19:57:17 EDT

Member Since

2002-08-01

Posts: 1438

Peter,

Whew, this is new one!  The thing about boats is there no such thing as square or plumb.  Everything is all faired curves and angles.  I guess what I would do is determine the midpoint of the transom on a line from gunnel to gunnel.  From this midpoint, draw a line down to the center of the curve at the bottom of the transom.  This curve has ~3” Radius and the center of it should be easy to determine.  Both gudgeons should be located on this transom centerline no matter if this line is exactly vertical or not.  As far as what the acceptable tolerance for being on the centerline is, you would have to ask Stan.  However, I would think it would be very helpful for him to have your measurement.  I can’t wait to hear the result of your measurement.

Good luck!

Roger Pihlaja 
S/V Dynamic Equilibrium 

Sent from my iPhone

See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting