The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

ROGER PIHLAJA



Rudder Askew

2020-05-30; 17:33:19 EDT

Member Since

2002-08-01

Posts: 1438

Peter,

The attached picture shows the GBI motor mount on S/V Dynamic Equilibrium’s stern.  I installed this motor mount myself, so maybe Stan hangs it on the transom differently than I did.  You’re right, the GBI motor mount is a very tall, bulky structure.  But, with my wife holding one end of the tape, I was able to snake a tape measure across the transom behind the motor mount to determine the center point.

Roger Pihlaja
S/V Dynamic Equilibrium



Sent from Mail<https://go.microsoft.com/fwlink/?LinkId=550986> for Windows 10

From: Peter Nyberg<mailto:peter at sunnybeeches.com>
Sent: Saturday, May 30, 2020 5:11 PM
To: The Rhodes 22 Email List<mailto:rhodes22-list at rhodes22.org>
Subject: Re: [Rhodes22-list] Rudder Askew

Roger,

I’m guessing the Dynamic Equilibrium does not have a General Boats outboard motor lift on her transom.  This is a pretty large structure that runs from just above the waterline to the top of the aft cockpit combing, and makes any horizontal measurement across the transom somewhere between difficult and impossible.

I was able to find the center point at the bottom of the transom that you describe.  I found that by keeping the bottom of the boat in view and sighting down the ‘V’ to the keel, the low point of the transom was pretty easy to identify with reasonable accuracy (but probably not within a millimeter).

Since I can’t identify a usable upper center point, I think I’ll have to settle for using a vertical line from the lower center point as my transom centerline.  Given that I’ve leveled the boat port-to-starboard across the cockpit combings, I think a vertical line is as close to ‘right’ as any straight line on a boat can be.

Based on this, I find that my upper gudgeon is 3/16” to starboard and my lower gudgeon is 1/4” to port.

I haven’t had time to give this a lot of thought, but I’m thinking of calling the upper gudgeon ‘close enough’, and shifting the lower gudgeon 7/16” to starboard.

—Peter


GBI Motor Mount & Honda 8 hp 25 Inch Shaft Outboard.jpg
See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting