The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Mark Whipple



CB Pennant drain

2020-06-15; 20:10:52 EDT

Member Since

2019-10-09

Posts: 120

Hi All,

If this is in the archives somewhere let me know. I've done a little
searching on Nabble and didn't find what I needed. I need to replace the
hose that connects the drain the CB/diamondboard pennant runs through.

It looks like the OD of the lower section (closer to the CB) is 7/8" OD.
The top section where the pennant exits is about 1" ID, so I'm guessing
it's about 1 1/4" OD. Total possible length looks to be about 10". The
difference in diameters partially explains the abomination that I removed.
Someone tried to mate two different hoses with clamps and lots of silicone.

What has worked well for you in replacing this drain hose? I am wondering
if I can get a hose that will fit the upper part of the drain, and then use
a modified section of that same hose to bring the bottom fitting closer to
1 1/4". Then I'd put the larger hose over the smaller one, clamping the
smaller section low and then the larger, overlapping hose as well.

Thanks
Mark Whipple
Boston, MA

2000 R22 Luna Mia
1986 Nimble 30 (for sale)
1982 ComPac 16 (for sale)
See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting