2020-06-20; 09:47:14 EDT
Member Since
2019-06-04
Posts: 463
I replaced my masthead light last winter and changed it from a steaming light to an all around anchor light in the process. My new masthead light has separate hot wires so the front and back can be powered independently but I don't have the wiring and switches in place to do that. I considered doing the work to make that possible. I unscrewed the switch panel in the cockpit, but it is hard to get a good look back there since all the wires are fairly tight and I could not pull out the switch panel far. Would it be necessary to remove the galley to get back there and access all the wires? Since I now have an all around anchor light but no steaming light, I had been thinking about a workaround until I want to do some wiring work and add another switch for the rear portion of my masthead light. At Home Depot, I saw a battery powered LED strip by Milwaukee tools that is water, dust, and impact resistant. On the low setting (100 lumens), it will last 16 hours on 2 AA batteries. One of these lights cost $20. https://www.homedepot.com/p/Milwaukee-300-Lumens-LED-Magnetic-Flood-Light-2108/306261360 I picked up 3 of these lights: one to face forward, one to face starboard, and one to face port. I used a velcro strip to run through the hooks on the back of the lights and over the boom. It's easy to put them on around the mast temporarily and then wrap them up in a bundle for storage in the cabin when not in use. Preferable options would be to wire up separate switches to the front and back lights on my masthead light, or wire up a separate steaming light 2/3 of the way up the mast as you typically see. If you don't want to mess with the wiring, the setup described in this post is a simple battery powered work around for a steaming light to go along with the running lights. I know some people will use the masthead light just facing forward as a steaming light and then use a lantern for an anchor light. My reasoning was that I would prefer to have the anchor light running off the boat battery since that is on for awhile (though it is LED and low draw), but the steaming lights would not be used for long periods so it was a better fit for smaller batteries. While I was at this, I put some reflective tape on the mast just above the boom. It really lights up when a flashlight is shown on it and can make it more distinctive and easy to spot in anchorage. I attached a few photos for reference. I'm curious if others have both a steaming and all around anchor light wired up on their boats. ReflectiveTapeOnMastRS.JPG Steaming02RS.JPG Steaming03RS.JPG Steaming04RS.JPG Steaming01lightsTurnedOffRS.JPG Steaming05RS.JPG Steaming06RS.JPGSee the original archive post