Allyn,
The engine must be all the way down on the motor mount as well as the motor
tilt. There should be a control to change the motor angle independent of the
motor lift which should bring the prop closer to the stern.
You should note that in the pictures, the motor is slightly angled towards
the rudder and must point straight back or even slightly outboard (you can
compensate the thrust with the rudder).
Mike
s/v Wind Lass ('91)
Nissequogue River, NY
-----Original Message-----
From: Rhodes22-list <rhodes22-list-bounces at rhodes22.org> On Behalf Of Allyn
Baskerville
Sent: Tuesday, July 14, 2020 10:51 AM
To: The Rhodes 22 Email List <rhodes22-list at rhodes22.org>
Subject: [Rhodes22-list] Rudder-Engine Conflicts
I've been intending on getting photos taken since I posted this, and I'm at
the boat club several times a week and keep forgetting. The rudder blade is
down all the way, and I've tilted the engine and tried everything I can
think of to keep them from hitting each other. At best, the prop just barely
nicks the edge of the rudder blade as you can see in the one picture where
the blade is up (next to the engine). I now rarely motor in and out of my
slip (only when solo), so this is less of an issue, but I still need to
repair the damage to the rudder. I've not pulled my boat out of the water
since March, and I don't have an easy way to measure the distances.
ttachment.jpg>
ttachment-0001.jpg>
ttachment-0002.jpg>
×
Message to Webmaster:
To use your email application to send a messsage to the webmaster rather than this form,
.