The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Jay Friedland



How to: A Trouble-free Furling Main | Sail Magazine

2020-07-19; 18:42:30 EDT

Member Since

2002-08-24

Posts: 357

Hi, Tom,
I opted to work with Evolution Sails in 2014, may be still in Easton, MD.,
Scott Gibbs was the contact. They were good to work with, and the design
was unique for our boat, straight leech, and 2 vertical battens, 1/4” round
fiberglass rods, roughly at thirds, see attached photo, if it doesn’t get
stripped away.

Although I had some tweaks (more cosmetic than design- extended UV cover,
tack line, R22 numbers, etc.) in the beginning, it’s performed flawlessly,
especially this past year with Stan’s new outhaul car. I went through 2
previous outhaul car designs over the last 6 years, which made it a little
difficult to reef and furl in. The angle of the boom is critical to it’s
compactness in the mast, and it’s original stiffness took a few weeks to
settle in.

Over the battenless version, I reef & furl on a port tack, although it goes
right in when in irons or light winds (6-8 kts.) on starboard tack. It’s
about the same size and was the same cost as the Doyle version, and about
the same area UV cover. It is much stiffer than the single batten. If you
ever in the Ocean County, NJ /Long Beach Island area, I go out at least 3-4
times a week, now with masks, so a test sail is always available.

Jay Friedland
S/V Wanderlust, ‘97







R22.Vertical Battens.2017-10-04.jpg
See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting