The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Chris on LBI



Repair of Spider Cracks at Mast Step Tabernacle

2020-07-28; 12:34:43 EDT

Member Since

2019-04-26

Posts: 91

Great points that I had not considered (poor end grain holding ability and
end grain rot). I am a novice when it comes to this sort of boat
maintenance. The feedback raises a few questions for me. First question: If
the mast is stepped and un-stepped properly, it would seem that the force
acting on the screws should always be sheer force, not axial pull force,
right? Second question: Don't I want to make sure that absolutely no water
gets past the head of the screw and under the fiberglass to the core? I
presume that when a new boat is manufactured, the screws are sealed
sufficiently to prevent water infiltration to the wood core. Would the butyl
tape accomplish this? Should examination of the seal around these screws be
a routine part of a springtime inspection of the boat?



-----
Long Beach Island
--
Sent from: http://rhodes-22.1065344.n5.nabble.com/
See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting