The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Graham Stewart



Repair of Spider Cracks at Mast Step Tabernacle

2020-07-29; 22:10:02 EDT

Member Since

2005-04-29

Posts: 814

Chris:  If the gelcoat around the holes is mearly broken up a bit you should
be able to remove anything that is loose and fill it with the thickened
epoxy when you fill the holes. Given that the holes are covered with the
mast step anyway, you don't need to worry about the exposed epoxy. Epoxy
exposed to sunlight degrades quickly. I really like the idea of using
slivers of wood in the hole with the epoxy. I wish I had thought to do that.
I would not pack it hard with the wood slivers - maybe 50% wood and the rest
epoxy.
If the screw is inserted into the epoxy I see no reason or benefit from
removing the screws to inspect the holes. That might cause more problems
than it solves. One thing you should note is that screws driven into uncured
epoxy can be very difficult to remove and it is quite easy to strip the head
or even break it off. The wood slivers should help but if the screw is hard
to remove put a soldering iron on the head for a while. That softens the
epoxy and it will come out easily.

If this event reoccurs it is likely that the screw will pull out the epoxy
plug since it is much tougher than the core material, Hopefully this does
not happen very often but if it does the fix remains the same. 

Graham Stewart
Agile, Rodes 22, 1976
Kingston Ontario


See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting