The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Chris on LBI



Reconnecting the Tabernacle Screws Following Sacrificial Failure

2020-08-03; 13:45:45 EDT

Member Since

2019-04-26

Posts: 91

OK Everyone,

Thank you again for all of your input.

This is getting to be too much analysis and not enough sailing for my first
mate so I am going to pick (as Graham has suggested) the solution that I am
most comfortable with. I'm going to go with the previously-tried,
time-tested, generally-accepted, epoxy-only repair method. I am going to
fill the holes with epoxy, drill them out after it sets but before it cures.
I'll put the screws in after I drill (to tap the holes) then back them out
while the epoxy cures. After the season is over and we've lowered the mast
in a gentler fashion, I'll back the screws out and remove the tabernacle
plate so that I can make the gelcoat repairs. 

If at some point in the future I cause the mounting block to be ripped out
of the fiberglass due to a stepping/unstepping error, I'll be sure to
acknowledge Rick's cautionary words.

Thank you all for your time, knowledge, and interest!
Chris



-----
Long Beach Island
--
Sent from: http://rhodes-22.1065344.n5.nabble.com/
See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting