The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Richard MacArthur



Rhodes22-list Digest, Vol 4230, Issue 1

2020-08-05; 13:00:54 EDT

Member Since

2009-06-22

Posts: 46

With regard to the screws pulling out of the tabernacle, that happened to me about four years ago. The mast was at about 45 degrees but instead of the butt shooting across the foredeck and the mast falling, the butt hit the crane mounting and stopped. My attempts to fill the holes with short lengths of fiberglass and epoxy the new screws in didn't work. That did not hold the mast but pulled out. I decided to give the tabernacle extra help. I put the screws back I as before but this time I rigged two cables from the tabernacle bolt to the cleats on each side of the companionway, put protective covering where the cables contacted the deck, and tightened the cables with hardware bought turnbuckles. Now the tabernacle can't move and we crank the mast up and down with confidence.

See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting