2020-08-05; 14:50:57 EDT
Member Since
2019-04-26
Posts: 91
Based on yesterday's experience when Isaias blew through, I would add one more item to the checklist: make sure the anchor is firmly lashed to the bow rail. We had some good-sized waves when the windspeed got up into the 50s. All the rocking and rolling caused the anchor to jump out of its latched cradle. It then swung around for a few hours in the large waves before it was safe enough to board the boat. The swinging anchor dangling from the bow pulled a bolt out of the bow. This bolt holds a u-shaped pinned fitting that helps secure the anchor to the boat and is one of three bolts that hold the chainplate for the forward stay. It is going to be very tough to reach the spot where the bolt comes through the bow to put a washer and nut on the inside. As a side note, on my boat at least two of the three of these chainplate bolts fully penetrate the hull. Neither has a nut on the inside. They rely on the fiberglass to hold them in place ... which is probably fine since the forces are shear. But the anchor swinging wildly in all directions in the waves pulled the bolt through the hole. And as another aside, I discovered a few years ago that none of the bolts that hold the forward-ends of the aft railings had nuts on the inside. This is the point on each side where the aft rail returns to the rub rail. All six bolts (three on each side) penetrate the hull but are only threaded into the fiberglass. I added washers and nuts to each of them after a few pulled out. In this case, some of the typical forces are not shear ... like when the skipper leans against a windward rail. ----- Long Beach Island -- Sent from: http://rhodes-22.1065344.n5.nabble.com/See the original archive post