< prior
Back to Month
Go to Thread
2020-08-26; 11:42:05 EDT
Member Since
2019-10-09
Posts: 120
FWIW, I'm pretty sure the drive is at about the same depth as the keel. I'll try to take a picture from the side later today. Also the rudder redirects some of the prop wash since the prop is in front. I haven't had it in the water yet this year (soon!) but I recall the feeling of the prop wash on the wheel was a little weird. Yes, my boat has a wheel and a self-tending jib, too. Not sure if it will get up on a plane. We'll see. MarkSee the original archive post
On Wed, Aug 26, 2020 at 11:31 AM Ric Stott <ric at stottarchitecture.com> wrote: > Cory - that’s a really interesting install. > Is 15 HP enough to get on a plane? > It would not work for my needs - it’s too deep. > I would need the prop to be no deeper than the bottom of the keel, and I > would mount it in the middle of the cockpit floor, about a foot aft of the > end of the keel, understanding that the motor head (probably electric and > smaller than the Yamaha head) would require a low cover above the cockpit > floor. > I would also like it to be a steerable sail drive with a remote. > Not sure that such a thing is even available. > Thanks > > Richard Stott, AIA, LEED AP > www.stottarchitecture.com > Office 631-283-1777 > Cell 516-965-3164 > > > > > > > On Aug 26, 2020, at 11:18 AM, Mark Whipple <mark at whipplefamily.com> > wrote: > > > > Ric, > > > > Here's a few pictures I dug up. I'm currently hunting for a source for > the > > zincs. > > > > Mark > > [image: Rhodes 22 MA CL 03.jpg] > > [image: Rhodes 22 MA CL 04.jpg] > > [image: Rhodes 22 MA CL 08.jpg] > > > > > > [image: 20200824_165705.jpg] > > > > On Wed, Aug 26, 2020 at 10:53 AM Richard Stott < > ric at stottarchitecture.com> > > wrote: > > > >> Mark > >> 15 HP is a lot of motor. > >> Can you show us a pic of where its mounted? > >> Any pics of it under the boat? > >> Can you share performance and maneuverability with us? > >> I’m dying to know more about this. > >> A steerable unit is my fantasy but a fixed one might work. > >> Ric > >> sv Dadventure > >> HBNY > >> > >> Richard Stott, AIA, LEED AP > >> www.stottarchitecture.com > >> Office 631-283-1777 > >> Cell 516-965-3164 > >> > >> > >> > >> > >> > >>> On Aug 26, 2020, at 10:43 AM, Mark Whipple <mark at whipplefamily.com> > >> wrote: > >>> > >>> Hi Richard, > >>> > >>> I purchased my 2000 R22 last year and it came with a 15hp Yamaha > >> saildrive. > >>> I haven't had a chance to use the boat much yet, but it seems like it > >> will > >>> address many of the issues with an outboard on the transom > >>> (raising/lowering, keeping the drive underwater). > >>> > >>> Unfortunately the company that made this saildrive is essentially out > of > >>> business. I am concerned about what I'll have to do once this saildrive > >>> needs a part I can't get or needs a costly repair. I'm not sure I like > >> the > >>> alternative solutions that involve a motor on the transom. Maybe I need > >> to > >>> start saving my pennies toward a replacement. Regarding that option, > the > >>> saildrives I've seen tend to have larger engine than mine - often a > >> diesel. > >>> Mine is essentially a Yamaha (made by Parsun) outboard head so it's not > >>> very tall. Maybe I'll be lucky and not have to solve the replacement > >>> problem. > >>> > >>> Mark > >>> > >>> -- > >>> Boston, MA > >>> > >>> 2000 R22 *Luna Mia* > >>> 1987 Nimble 30 *For Sale* > >>> 1982 Com-Pac 16 *For Sale* > >>> > >>> On Wed, Aug 26, 2020 at 10:14 AM Richard Stott < > >> ric at stottarchitecture.com> > >>> wrote: > >>> > >>>> Cary > >>>> My ’84 GB mount broke on spring launch the year and my Yamaha 8 went > in > >>>> the drink. > >>>> I purchased a motor mount from West marine immediately so I could > >> continue > >>>> to use the boat with a spare motor I happened to have on hand. > >>>> Its a stinky smoky ’99 Merc 2 stroke, but it always starts and runs > when > >>>> it need it - well almost always. > >>>> I talked it over on the list and discussed with Mike Riter a plan to > >>>> convert the GB mount to be equipped with a threaded gear (his sketch) > so > >>>> that the mont can be moved with a manual crank or an electric motor. > >>>> This would be huge advantage over the 6/1 tackle it came equipped > with. > >>>> I’ve been enjoying the boat too much to stop and refine that design of > >>>> Mikes - that’s a winter project. > >>>> > >>>> In any case the parallelogram type mount works fairly well, it has > pros > >>>> and cons. > >>>> One of the biggest cons is that the moro in the down position is > father > >>>> aft of the transom and will cavitate and lose thrust in larger waves, > >>>> especially with weight on the bow. > >>>> I will like the GB system (modified) over the alternative, but the > West > >>>> marine mount was easy to install and serves the immediate need. > >>>> (What I really want is an electric, steerable, remote controlled, 20 > hp > >>>> sail drive mounted right behind the keel trunk.) > >>>> It’s doable for approximately one tone of money. > >>>> > >>>> One way I use the boat is unusual. > >>>> I moore my boat 50 yards off shore. > >>>> I use a stand-up paddle board for a tender because it's light and easy > >> to > >>>> cary to the shore. > >>>> I then use the motor only, with the rudder up, to back the boat on to > >> the > >>>> beach to pick up provisions and of course my wife, who is not one to > >>>> paddle out to the boat. > >>>> Depending on the tide and the slope of the beach, I can sometimes put > >> the > >>>> stern right on the beach. > >>>> An opening in the stern rail, like the more modern R22s would be a > huge > >>>> asset for picking up passengers from the beach. (next year) > >>>> Ric > >>>> sv Dadventure > >>>> stay tuned for ‘motor mount mod’ updates > >>>> > >>>> > >>>> > >>>> Richard Stott, AIA, LEED AP > >>>> www.stottarchitecture.com <http://www.stottarchitecture.com/> > >>>> Office 631-283-1777 > >>>> Cell 516-965-3164 > >>>> > >>>> > >>>> > >>>> > >>>> > >>>>> On Aug 26, 2020, at 9:19 AM, Cary Tolbert <retiredtoby at gmail.com> > >> wrote: > >>>>> > >>>>> Preview attachment 20200825_174517.jpg > >>>>> 20200825_174517.jpg > >>>>> 4 MB > >>>>> < > >>>> > >> > https://mail.google.com/mail/u/0?ui=2&ik=be1ab8c6c5&attid=0.1&permmsgid=msg-a:r-7374969717110164997&th=1742adb6a4937cb8&view=att&disp=safe&realattid=1742adb12d8c3f23bf81 > >>>>> Once > >>>>> again HELP. Wed. the 25th I was motoring from my slip out on to the > >> lake > >>>>> and kerplunk. The motor raising part of the boat fell off with the > >> motor > >>>>> attached and still running. I also had it attached with a s/s chain. > >>>> Lucky > >>>>> or not.? ? ? Stan no longer makes the parts for an 86. He said he has > >>>> long > >>>>> moved to newer and hopefully better designs. It seems the starboard > >>>>> material used to let the motor slide in the rails failed. My question > >> is > >>>>> should I attempt to repair with parts of better materials or buy a > >>>>> gerneric system for raising and lowering one's motor . Say something > >>>> that > >>>>> would fit a Catalina 22? Looking for advice from the centuries of > >>>>> experience on the list > >>>>> Cary Tolbert S/V Whisper '86 > >>>>> Radford, VA > >>>> > >>>> > >>> > >>> -- > >>> Boston, MA > >>> > >>> 2000 R22 *Luna Mia* > >>> 1986 Nimble 30 *For Sale* > >>> 1982 Com-Pac 16 *For Sale* > >> > >> > > -------------- next part -------------- > > A non-text attachment was scrubbed... > > Name: 20200824_165705.jpg > > Type: image/jpeg > > Size: 652767 bytes > > Desc: not available > > URL: < > http://rhodes22.org/pipermail/rhodes22-list/attachments/20200826/730b3b80/attachment.jpg > > > > -------------- next part -------------- > > A non-text attachment was scrubbed... > > Name: Rhodes 22 MA CL 03.jpg > > Type: image/jpeg > > Size: 61722 bytes > > Desc: not available > > URL: < > http://rhodes22.org/pipermail/rhodes22-list/attachments/20200826/730b3b80/attachment-0001.jpg > > > > -------------- next part -------------- > > A non-text attachment was scrubbed... > > Name: Rhodes 22 MA CL 04.jpg > > Type: image/jpeg > > Size: 79585 bytes > > Desc: not available > > URL: < > http://rhodes22.org/pipermail/rhodes22-list/attachments/20200826/730b3b80/attachment-0002.jpg > > > > -------------- next part -------------- > > A non-text attachment was scrubbed... > > Name: Rhodes 22 MA CL 08.jpg > > Type: image/jpeg > > Size: 200670 bytes > > Desc: not available > > URL: < > http://rhodes22.org/pipermail/rhodes22-list/attachments/20200826/730b3b80/attachment-0003.jpg > > > >
To use your email application to send a messsage to the webmaster rather than this form, .
Your post is being sent... 