< prior
Back to Month
Go to Thread
2020-08-26; 15:17:35 EDT
Member Since
2020-03-29
Posts: 139
Electric sail drive would be the ultimate. Sent from my iPhoneSee the original archive post
> On Aug 26, 2020, at 12:06 PM, Jesse Shumaker <jesse.laten.shumaker at gmail.com> wrote: > > ?Mark, it sounds like your R22 has even more bells and whistles than most! > I'm curious about your self tending jib. I've only seen that feature on > larger boats such as Island Packets. Have you found the self tending jib > to work well? > > Jesse Shumaker > S/V Zephyr > >> On Wed, Aug 26, 2020 at 10:42 AM Mark Whipple <mark at whipplefamily.com> >> wrote: >> >> FWIW, I'm pretty sure the drive is at about the same depth as the keel. >> I'll try to take a picture from the side later today. Also the rudder >> redirects some of the prop wash since the prop is in front. I haven't >> had it in the water yet this year (soon!) but I recall the feeling of the >> prop wash on the wheel was a little weird. Yes, my boat has a wheel and a >> self-tending jib, too. Not sure if it will get up on a plane. We'll see. >> >> Mark >> >> On Wed, Aug 26, 2020 at 11:31 AM Ric Stott <ric at stottarchitecture.com> >> wrote: >> >>> Cory - that’s a really interesting install. >>> Is 15 HP enough to get on a plane? >>> It would not work for my needs - it’s too deep. >>> I would need the prop to be no deeper than the bottom of the keel, and I >>> would mount it in the middle of the cockpit floor, about a foot aft of >> the >>> end of the keel, understanding that the motor head (probably electric >> and >>> smaller than the Yamaha head) would require a low cover above the cockpit >>> floor. >>> I would also like it to be a steerable sail drive with a remote. >>> Not sure that such a thing is even available. >>> Thanks >>> >>> Richard Stott, AIA, LEED AP >>> www.stottarchitecture.com >>> Office 631-283-1777 >>> Cell 516-965-3164 >>> >>> >>> >>> >>> >>>> On Aug 26, 2020, at 11:18 AM, Mark Whipple <mark at whipplefamily.com> >>> wrote: >>>> >>>> Ric, >>>> >>>> Here's a few pictures I dug up. I'm currently hunting for a source for >>> the >>>> zincs. >>>> >>>> Mark >>>> [image: Rhodes 22 MA CL 03.jpg] >>>> [image: Rhodes 22 MA CL 04.jpg] >>>> [image: Rhodes 22 MA CL 08.jpg] >>>> >>>> >>>> [image: 20200824_165705.jpg] >>>> >>>> On Wed, Aug 26, 2020 at 10:53 AM Richard Stott < >>> ric at stottarchitecture.com> >>>> wrote: >>>> >>>>> Mark >>>>> 15 HP is a lot of motor. >>>>> Can you show us a pic of where its mounted? >>>>> Any pics of it under the boat? >>>>> Can you share performance and maneuverability with us? >>>>> I’m dying to know more about this. >>>>> A steerable unit is my fantasy but a fixed one might work. >>>>> Ric >>>>> sv Dadventure >>>>> HBNY >>>>> >>>>> Richard Stott, AIA, LEED AP >>>>> www.stottarchitecture.com >>>>> Office 631-283-1777 >>>>> Cell 516-965-3164 >>>>> >>>>> >>>>> >>>>> >>>>> >>>>>> On Aug 26, 2020, at 10:43 AM, Mark Whipple <mark at whipplefamily.com> >>>>> wrote: >>>>>> >>>>>> Hi Richard, >>>>>> >>>>>> I purchased my 2000 R22 last year and it came with a 15hp Yamaha >>>>> saildrive. >>>>>> I haven't had a chance to use the boat much yet, but it seems like it >>>>> will >>>>>> address many of the issues with an outboard on the transom >>>>>> (raising/lowering, keeping the drive underwater). >>>>>> >>>>>> Unfortunately the company that made this saildrive is essentially out >>> of >>>>>> business. I am concerned about what I'll have to do once this >> saildrive >>>>>> needs a part I can't get or needs a costly repair. I'm not sure I >> like >>>>> the >>>>>> alternative solutions that involve a motor on the transom. Maybe I >> need >>>>> to >>>>>> start saving my pennies toward a replacement. Regarding that option, >>> the >>>>>> saildrives I've seen tend to have larger engine than mine - often a >>>>> diesel. >>>>>> Mine is essentially a Yamaha (made by Parsun) outboard head so it's >> not >>>>>> very tall. Maybe I'll be lucky and not have to solve the replacement >>>>>> problem. >>>>>> >>>>>> Mark >>>>>> >>>>>> -- >>>>>> Boston, MA >>>>>> >>>>>> 2000 R22 *Luna Mia* >>>>>> 1987 Nimble 30 *For Sale* >>>>>> 1982 Com-Pac 16 *For Sale* >>>>>> >>>>>> On Wed, Aug 26, 2020 at 10:14 AM Richard Stott < >>>>> ric at stottarchitecture.com> >>>>>> wrote: >>>>>> >>>>>>> Cary >>>>>>> My ’84 GB mount broke on spring launch the year and my Yamaha 8 went >>> in >>>>>>> the drink. >>>>>>> I purchased a motor mount from West marine immediately so I could >>>>> continue >>>>>>> to use the boat with a spare motor I happened to have on hand. >>>>>>> Its a stinky smoky ’99 Merc 2 stroke, but it always starts and runs >>> when >>>>>>> it need it - well almost always. >>>>>>> I talked it over on the list and discussed with Mike Riter a plan to >>>>>>> convert the GB mount to be equipped with a threaded gear (his >> sketch) >>> so >>>>>>> that the mont can be moved with a manual crank or an electric motor. >>>>>>> This would be huge advantage over the 6/1 tackle it came equipped >>> with. >>>>>>> I’ve been enjoying the boat too much to stop and refine that design >> of >>>>>>> Mikes - that’s a winter project. >>>>>>> >>>>>>> In any case the parallelogram type mount works fairly well, it has >>> pros >>>>>>> and cons. >>>>>>> One of the biggest cons is that the moro in the down position is >>> father >>>>>>> aft of the transom and will cavitate and lose thrust in larger >> waves, >>>>>>> especially with weight on the bow. >>>>>>> I will like the GB system (modified) over the alternative, but the >>> West >>>>>>> marine mount was easy to install and serves the immediate need. >>>>>>> (What I really want is an electric, steerable, remote controlled, >> 20 >>> hp >>>>>>> sail drive mounted right behind the keel trunk.) >>>>>>> It’s doable for approximately one tone of money. >>>>>>> >>>>>>> One way I use the boat is unusual. >>>>>>> I moore my boat 50 yards off shore. >>>>>>> I use a stand-up paddle board for a tender because it's light and >> easy >>>>> to >>>>>>> cary to the shore. >>>>>>> I then use the motor only, with the rudder up, to back the boat on >> to >>>>> the >>>>>>> beach to pick up provisions and of course my wife, who is not one >> to >>>>>>> paddle out to the boat. >>>>>>> Depending on the tide and the slope of the beach, I can sometimes >> put >>>>> the >>>>>>> stern right on the beach. >>>>>>> An opening in the stern rail, like the more modern R22s would be a >>> huge >>>>>>> asset for picking up passengers from the beach. (next year) >>>>>>> Ric >>>>>>> sv Dadventure >>>>>>> stay tuned for ‘motor mount mod’ updates >>>>>>> >>>>>>> >>>>>>> >>>>>>> Richard Stott, AIA, LEED AP >>>>>>> www.stottarchitecture.com <http://www.stottarchitecture.com/> >>>>>>> Office 631-283-1777 >>>>>>> Cell 516-965-3164 >>>>>>> >>>>>>> >>>>>>> >>>>>>> >>>>>>> >>>>>>>> On Aug 26, 2020, at 9:19 AM, Cary Tolbert <retiredtoby at gmail.com> >>>>> wrote: >>>>>>>> >>>>>>>> Preview attachment 20200825_174517.jpg >>>>>>>> 20200825_174517.jpg >>>>>>>> 4 MB >>>>>>>> < >>>>>>> >>>>> >>> >> https://mail.google.com/mail/u/0?ui=2&ik=be1ab8c6c5&attid=0.1&permmsgid=msg-a:r-7374969717110164997&th=1742adb6a4937cb8&view=att&disp=safe&realattid=1742adb12d8c3f23bf81 >>>>>>>> Once >>>>>>>> again HELP. Wed. the 25th I was motoring from my slip out on to the >>>>> lake >>>>>>>> and kerplunk. The motor raising part of the boat fell off with the >>>>> motor >>>>>>>> attached and still running. I also had it attached with a s/s >> chain. >>>>>>> Lucky >>>>>>>> or not.? ? ? Stan no longer makes the parts for an 86. He said he >> has >>>>>>> long >>>>>>>> moved to newer and hopefully better designs. It seems the starboard >>>>>>>> material used to let the motor slide in the rails failed. My >> question >>>>> is >>>>>>>> should I attempt to repair with parts of better materials or buy a >>>>>>>> gerneric system for raising and lowering one's motor . Say >> something >>>>>>> that >>>>>>>> would fit a Catalina 22? Looking for advice from the centuries of >>>>>>>> experience on the list >>>>>>>> Cary Tolbert S/V Whisper '86 >>>>>>>> Radford, VA >>>>>>> >>>>>>> >>>>>> >>>>>> -- >>>>>> Boston, MA >>>>>> >>>>>> 2000 R22 *Luna Mia* >>>>>> 1986 Nimble 30 *For Sale* >>>>>> 1982 Com-Pac 16 *For Sale* >>>>> >>>>> >>>> -------------- next part -------------- >>>> A non-text attachment was scrubbed... >>>> Name: 20200824_165705.jpg >>>> Type: image/jpeg >>>> Size: 652767 bytes >>>> Desc: not available >>>> URL: < >>> >> http://rhodes22.org/pipermail/rhodes22-list/attachments/20200826/730b3b80/attachment.jpg >>>> >>>> -------------- next part -------------- >>>> A non-text attachment was scrubbed... >>>> Name: Rhodes 22 MA CL 03.jpg >>>> Type: image/jpeg >>>> Size: 61722 bytes >>>> Desc: not available >>>> URL: < >>> >> http://rhodes22.org/pipermail/rhodes22-list/attachments/20200826/730b3b80/attachment-0001.jpg >>>> >>>> -------------- next part -------------- >>>> A non-text attachment was scrubbed... >>>> Name: Rhodes 22 MA CL 04.jpg >>>> Type: image/jpeg >>>> Size: 79585 bytes >>>> Desc: not available >>>> URL: < >>> >> http://rhodes22.org/pipermail/rhodes22-list/attachments/20200826/730b3b80/attachment-0002.jpg >>>> >>>> -------------- next part -------------- >>>> A non-text attachment was scrubbed... >>>> Name: Rhodes 22 MA CL 08.jpg >>>> Type: image/jpeg >>>> Size: 200670 bytes >>>> Desc: not available >>>> URL: < >>> >> http://rhodes22.org/pipermail/rhodes22-list/attachments/20200826/730b3b80/attachment-0003.jpg >>>> >>> >>> >>
To use your email application to send a messsage to the webmaster rather than this form, .
Your post is being sent... 