< prior
Back to Month
Go to Thread
2020-08-26; 17:30:33 EDT
Member Since
2020-07-08
Posts: 278
Stan, your message was blank. FYI.See the original archive post
On Wed, Aug 26, 2020, 4:17 PM stan <stan at generalboats.com> wrote: > On 8/26/20 4:48 PM, Mark West via Rhodes22-list wrote: > > Believe that sailboat 2 maby 3 years ago was in the Annapolis boat show > . think sold to some one on west cost Seattle? Stan did design and build > one with Torpedo's equipment mounted inside lazaret Mark > > > > -----Original Message----- > > From: Tom Van Heule <tom.vanheule at intrinsicprograms.com> > > To: Scott Andrews <sea20 at verizon.net>; The Rhodes 22 Email List < > rhodes22-list at rhodes22.org> > > Sent: Wed, Aug 26, 2020 4:33 pm > > Subject: Re: [Rhodes22-list] Saildrive > > > > Stan had mentioned to me he had an idea where it would even retract, > based > > on some torqueedo parts. > > > > On Wed, Aug 26, 2020, 2:17 PM Scott Andrews via Rhodes22-list < > > rhodes22-list at rhodes22.org> wrote: > > > >> Electric sail drive would be the ultimate. > >> > >> Sent from my iPhone > >> > >>> On Aug 26, 2020, at 12:06 PM, Jesse Shumaker < > >> jesse.laten.shumaker at gmail.com> wrote: > >>> ?Mark, it sounds like your R22 has even more bells and whistles than > >> most! > >>> I'm curious about your self tending jib. I've only seen that feature > on > >>> larger boats such as Island Packets. Have you found the self tending > jib > >>> to work well? > >>> > >>> Jesse Shumaker > >>> S/V Zephyr > >>> > >>>> On Wed, Aug 26, 2020 at 10:42 AM Mark Whipple <mark at whipplefamily.com > > > >>>> wrote: > >>>> > >>>> FWIW, I'm pretty sure the drive is at about the same depth as the > keel. > >>>> I'll try to take a picture from the side later today. Also the rudder > >>>> redirects some of the prop wash since the prop is in front. I haven't > >>>> had it in the water yet this year (soon!) but I recall the feeling of > >> the > >>>> prop wash on the wheel was a little weird. Yes, my boat has a wheel > and > >> a > >>>> self-tending jib, too. Not sure if it will get up on a plane. We'll > see. > >>>> > >>>> Mark > >>>> > >>>> On Wed, Aug 26, 2020 at 11:31 AM Ric Stott <ric at stottarchitecture.com > > > >>>> wrote: > >>>> > >>>>> Cory - that’s a really interesting install. > >>>>> Is 15 HP enough to get on a plane? > >>>>> It would not work for my needs - it’s too deep. > >>>>> I would need the prop to be no deeper than the bottom of the keel, > and > >> I > >>>>> would mount it in the middle of the cockpit floor, about a foot aft > of > >>>> the > >>>>> end of the keel, understanding that the motor head (probably > electric > >>>> and > >>>>> smaller than the Yamaha head) would require a low cover above the > >> cockpit > >>>>> floor. > >>>>> I would also like it to be a steerable sail drive with a remote. > >>>>> Not sure that such a thing is even available. > >>>>> Thanks > >>>>> > >>>>> Richard Stott, AIA, LEED AP > >>>>> www.stottarchitecture.com > >>>>> Office 631-283-1777 > >>>>> Cell 516-965-3164 > >>>>> > >>>>> > >>>>> > >>>>> > >>>>> > >>>>>> On Aug 26, 2020, at 11:18 AM, Mark Whipple <mark at whipplefamily.com> > >>>>> wrote: > >>>>>> Ric, > >>>>>> > >>>>>> Here's a few pictures I dug up. I'm currently hunting for a source > for > >>>>> the > >>>>>> zincs. > >>>>>> > >>>>>> Mark > >>>>>> [image: Rhodes 22 MA CL 03.jpg] > >>>>>> [image: Rhodes 22 MA CL 04.jpg] > >>>>>> [image: Rhodes 22 MA CL 08.jpg] > >>>>>> > >>>>>> > >>>>>> [image: 20200824_165705.jpg] > >>>>>> > >>>>>> On Wed, Aug 26, 2020 at 10:53 AM Richard Stott < > >>>>> ric at stottarchitecture.com> > >>>>>> wrote: > >>>>>> > >>>>>>> Mark > >>>>>>> 15 HP is a lot of motor. > >>>>>>> Can you show us a pic of where its mounted? > >>>>>>> Any pics of it under the boat? > >>>>>>> Can you share performance and maneuverability with us? > >>>>>>> I’m dying to know more about this. > >>>>>>> A steerable unit is my fantasy but a fixed one might work. > >>>>>>> Ric > >>>>>>> sv Dadventure > >>>>>>> HBNY > >>>>>>> > >>>>>>> Richard Stott, AIA, LEED AP > >>>>>>> www.stottarchitecture.com > >>>>>>> Office 631-283-1777 > >>>>>>> Cell 516-965-3164 > >>>>>>> > >>>>>>> > >>>>>>> > >>>>>>> > >>>>>>> > >>>>>>>> On Aug 26, 2020, at 10:43 AM, Mark Whipple < > mark at whipplefamily.com> > >>>>>>> wrote: > >>>>>>>> Hi Richard, > >>>>>>>> > >>>>>>>> I purchased my 2000 R22 last year and it came with a 15hp Yamaha > >>>>>>> saildrive. > >>>>>>>> I haven't had a chance to use the boat much yet, but it seems like > >> it > >>>>>>> will > >>>>>>>> address many of the issues with an outboard on the transom > >>>>>>>> (raising/lowering, keeping the drive underwater). > >>>>>>>> > >>>>>>>> Unfortunately the company that made this saildrive is essentially > >> out > >>>>> of > >>>>>>>> business. I am concerned about what I'll have to do once this > >>>> saildrive > >>>>>>>> needs a part I can't get or needs a costly repair. I'm not sure I > >>>> like > >>>>>>> the > >>>>>>>> alternative solutions that involve a motor on the transom. Maybe I > >>>> need > >>>>>>> to > >>>>>>>> start saving my pennies toward a replacement. Regarding that > option, > >>>>> the > >>>>>>>> saildrives I've seen tend to have larger engine than mine - often > a > >>>>>>> diesel. > >>>>>>>> Mine is essentially a Yamaha (made by Parsun) outboard head so > it's > >>>> not > >>>>>>>> very tall. Maybe I'll be lucky and not have to solve the > replacement > >>>>>>>> problem. > >>>>>>>> > >>>>>>>> Mark > >>>>>>>> > >>>>>>>> -- > >>>>>>>> Boston, MA > >>>>>>>> > >>>>>>>> 2000 R22 *Luna Mia* > >>>>>>>> 1987 Nimble 30 *For Sale* > >>>>>>>> 1982 Com-Pac 16 *For Sale* > >>>>>>>> > >>>>>>>> On Wed, Aug 26, 2020 at 10:14 AM Richard Stott < > >>>>>>> ric at stottarchitecture.com> > >>>>>>>> wrote: > >>>>>>>> > >>>>>>>>> Cary > >>>>>>>>> My ’84 GB mount broke on spring launch the year and my Yamaha 8 > >> went > >>>>> in > >>>>>>>>> the drink. > >>>>>>>>> I purchased a motor mount from West marine immediately so I could > >>>>>>> continue > >>>>>>>>> to use the boat with a spare motor I happened to have on hand. > >>>>>>>>> Its a stinky smoky ’99 Merc 2 stroke, but it always starts and > runs > >>>>> when > >>>>>>>>> it need it - well almost always. > >>>>>>>>> I talked it over on the list and discussed with Mike Riter a plan > >> to > >>>>>>>>> convert the GB mount to be equipped with a threaded gear (his > >>>> sketch) > >>>>> so > >>>>>>>>> that the mont can be moved with a manual crank or an electric > >> motor. > >>>>>>>>> This would be huge advantage over the 6/1 tackle it came equipped > >>>>> with. > >>>>>>>>> I’ve been enjoying the boat too much to stop and refine that > design > >>>> of > >>>>>>>>> Mikes - that’s a winter project. > >>>>>>>>> > >>>>>>>>> In any case the parallelogram type mount works fairly well, it > has > >>>>> pros > >>>>>>>>> and cons. > >>>>>>>>> One of the biggest cons is that the moro in the down position is > >>>>> father > >>>>>>>>> aft of the transom and will cavitate and lose thrust in larger > >>>> waves, > >>>>>>>>> especially with weight on the bow. > >>>>>>>>> I will like the GB system (modified) over the alternative, but > the > >>>>> West > >>>>>>>>> marine mount was easy to install and serves the immediate need. > >>>>>>>>> (What I really want is an electric, steerable, remote > controlled, > >>>> 20 > >>>>> hp > >>>>>>>>> sail drive mounted right behind the keel trunk.) > >>>>>>>>> It’s doable for approximately one tone of money. > >>>>>>>>> > >>>>>>>>> One way I use the boat is unusual. > >>>>>>>>> I moore my boat 50 yards off shore. > >>>>>>>>> I use a stand-up paddle board for a tender because it's light and > >>>> easy > >>>>>>> to > >>>>>>>>> cary to the shore. > >>>>>>>>> I then use the motor only, with the rudder up, to back the boat > on > >>>> to > >>>>>>> the > >>>>>>>>> beach to pick up provisions and of course my wife, who is not > one > >>>> to > >>>>>>>>> paddle out to the boat. > >>>>>>>>> Depending on the tide and the slope of the beach, I can sometimes > >>>> put > >>>>>>> the > >>>>>>>>> stern right on the beach. > >>>>>>>>> An opening in the stern rail, like the more modern R22s would be > a > >>>>> huge > >>>>>>>>> asset for picking up passengers from the beach. (next year) > >>>>>>>>> Ric > >>>>>>>>> sv Dadventure > >>>>>>>>> stay tuned for ‘motor mount mod’ updates > >>>>>>>>> > >>>>>>>>> > >>>>>>>>> > >>>>>>>>> Richard Stott, AIA, LEED AP > >>>>>>>>> www.stottarchitecture.com <http://www.stottarchitecture.com/> > >>>>>>>>> Office 631-283-1777 > >>>>>>>>> Cell 516-965-3164 > >>>>>>>>> > >>>>>>>>> > >>>>>>>>> > >>>>>>>>> > >>>>>>>>> > >>>>>>>>>> On Aug 26, 2020, at 9:19 AM, Cary Tolbert < > retiredtoby at gmail.com> > >>>>>>> wrote: > >>>>>>>>>> Preview attachment 20200825_174517.jpg > >>>>>>>>>> 20200825_174517.jpg > >>>>>>>>>> 4 MB > >>>>>>>>>> < > >> > https://mail.google.com/mail/u/0?ui=2&ik=be1ab8c6c5&attid=0.1&permmsgid=msg-a:r-7374969717110164997&th=1742adb6a4937cb8&view=att&disp=safe&realattid=1742adb12d8c3f23bf81 > >>>>>>>>>> Once > >>>>>>>>>> again HELP. Wed. the 25th I was motoring from my slip out on to > >> the > >>>>>>> lake > >>>>>>>>>> and kerplunk. The motor raising part of the boat fell off with > the > >>>>>>> motor > >>>>>>>>>> attached and still running. I also had it attached with a s/s > >>>> chain. > >>>>>>>>> Lucky > >>>>>>>>>> or not.? ? ? Stan no longer makes the parts for an 86. He said > he > >>>> has > >>>>>>>>> long > >>>>>>>>>> moved to newer and hopefully better designs. It seems the > >> starboard > >>>>>>>>>> material used to let the motor slide in the rails failed. My > >>>> question > >>>>>>> is > >>>>>>>>>> should I attempt to repair with parts of better materials or > buy a > >>>>>>>>>> gerneric system for raising and lowering one's motor . Say > >>>> something > >>>>>>>>> that > >>>>>>>>>> would fit a Catalina 22? Looking for advice from the centuries > of > >>>>>>>>>> experience on the list > >>>>>>>>>> Cary Tolbert S/V Whisper '86 > >>>>>>>>>> Radford, VA > >>>>>>>>> > >>>>>>>> -- > >>>>>>>> Boston, MA > >>>>>>>> > >>>>>>>> 2000 R22 *Luna Mia* > >>>>>>>> 1986 Nimble 30 *For Sale* > >>>>>>>> 1982 Com-Pac 16 *For Sale* > >>>>>>> > >>>>>> -------------- next part -------------- > >>>>>> A non-text attachment was scrubbed... > >>>>>> Name: 20200824_165705.jpg > >>>>>> Type: image/jpeg > >>>>>> Size: 652767 bytes > >>>>>> Desc: not available > >>>>>> URL: < > >> > http://rhodes22.org/pipermail/rhodes22-list/attachments/20200826/730b3b80/attachment.jpg > >>>>>> -------------- next part -------------- > >>>>>> A non-text attachment was scrubbed... > >>>>>> Name: Rhodes 22 MA CL 03.jpg > >>>>>> Type: image/jpeg > >>>>>> Size: 61722 bytes > >>>>>> Desc: not available > >>>>>> URL: < > >> > http://rhodes22.org/pipermail/rhodes22-list/attachments/20200826/730b3b80/attachment-0001.jpg > >>>>>> -------------- next part -------------- > >>>>>> A non-text attachment was scrubbed... > >>>>>> Name: Rhodes 22 MA CL 04.jpg > >>>>>> Type: image/jpeg > >>>>>> Size: 79585 bytes > >>>>>> Desc: not available > >>>>>> URL: < > >> > http://rhodes22.org/pipermail/rhodes22-list/attachments/20200826/730b3b80/attachment-0002.jpg > >>>>>> -------------- next part -------------- > >>>>>> A non-text attachment was scrubbed... > >>>>>> Name: Rhodes 22 MA CL 08.jpg > >>>>>> Type: image/jpeg > >>>>>> Size: 200670 bytes > >>>>>> Desc: not available > >>>>>> URL: < > >> > http://rhodes22.org/pipermail/rhodes22-list/attachments/20200826/730b3b80/attachment-0003.jpg > >>>>> > >> > >
To use your email application to send a messsage to the webmaster rather than this form, .
Your post is being sent... 