< prior
Back to Month
Go to Thread
2020-08-26; 17:41:05 EDT
Member Since
2019-04-30
Posts: 151
error - ignoreSee the original archive post
On 8/26/20 5:30 PM, Tom Van Heule wrote: > Stan, your message was blank. FYI. > > On Wed, Aug 26, 2020, 4:17 PM stan <stan at generalboats.com> wrote: > >> On 8/26/20 4:48 PM, Mark West via Rhodes22-list wrote: >>> Believe that sailboat 2 maby 3 years ago was in the Annapolis boat show >> . think sold to some one on west cost Seattle? Stan did design and build >> one with Torpedo's equipment mounted inside lazaret Mark >>> -----Original Message----- >>> From: Tom Van Heule <tom.vanheule at intrinsicprograms.com> >>> To: Scott Andrews <sea20 at verizon.net>; The Rhodes 22 Email List < >> rhodes22-list at rhodes22.org> >>> Sent: Wed, Aug 26, 2020 4:33 pm >>> Subject: Re: [Rhodes22-list] Saildrive >>> >>> Stan had mentioned to me he had an idea where it would even retract, >> based >>> on some torqueedo parts. >>> >>> On Wed, Aug 26, 2020, 2:17 PM Scott Andrews via Rhodes22-list < >>> rhodes22-list at rhodes22.org> wrote: >>> >>>> Electric sail drive would be the ultimate. >>>> >>>> Sent from my iPhone >>>> >>>>> On Aug 26, 2020, at 12:06 PM, Jesse Shumaker < >>>> jesse.laten.shumaker at gmail.com> wrote: >>>>> ?Mark, it sounds like your R22 has even more bells and whistles than >>>> most! >>>>> I'm curious about your self tending jib. I've only seen that feature >> on >>>>> larger boats such as Island Packets. Have you found the self tending >> jib >>>>> to work well? >>>>> >>>>> Jesse Shumaker >>>>> S/V Zephyr >>>>> >>>>>> On Wed, Aug 26, 2020 at 10:42 AM Mark Whipple <mark at whipplefamily.com >>>>>> wrote: >>>>>> >>>>>> FWIW, I'm pretty sure the drive is at about the same depth as the >> keel. >>>>>> I'll try to take a picture from the side later today. Also the rudder >>>>>> redirects some of the prop wash since the prop is in front. I haven't >>>>>> had it in the water yet this year (soon!) but I recall the feeling of >>>> the >>>>>> prop wash on the wheel was a little weird. Yes, my boat has a wheel >> and >>>> a >>>>>> self-tending jib, too. Not sure if it will get up on a plane. We'll >> see. >>>>>> Mark >>>>>> >>>>>> On Wed, Aug 26, 2020 at 11:31 AM Ric Stott <ric at stottarchitecture.com >>>>>> wrote: >>>>>> >>>>>>> Cory - that’s a really interesting install. >>>>>>> Is 15 HP enough to get on a plane? >>>>>>> It would not work for my needs - it’s too deep. >>>>>>> I would need the prop to be no deeper than the bottom of the keel, >> and >>>> I >>>>>>> would mount it in the middle of the cockpit floor, about a foot aft >> of >>>>>> the >>>>>>> end of the keel, understanding that the motor head (probably >> electric >>>>>> and >>>>>>> smaller than the Yamaha head) would require a low cover above the >>>> cockpit >>>>>>> floor. >>>>>>> I would also like it to be a steerable sail drive with a remote. >>>>>>> Not sure that such a thing is even available. >>>>>>> Thanks >>>>>>> >>>>>>> Richard Stott, AIA, LEED AP >>>>>>> www.stottarchitecture.com >>>>>>> Office 631-283-1777 >>>>>>> Cell 516-965-3164 >>>>>>> >>>>>>> >>>>>>> >>>>>>> >>>>>>> >>>>>>>> On Aug 26, 2020, at 11:18 AM, Mark Whipple <mark at whipplefamily.com> >>>>>>> wrote: >>>>>>>> Ric, >>>>>>>> >>>>>>>> Here's a few pictures I dug up. I'm currently hunting for a source >> for >>>>>>> the >>>>>>>> zincs. >>>>>>>> >>>>>>>> Mark >>>>>>>> [image: Rhodes 22 MA CL 03.jpg] >>>>>>>> [image: Rhodes 22 MA CL 04.jpg] >>>>>>>> [image: Rhodes 22 MA CL 08.jpg] >>>>>>>> >>>>>>>> >>>>>>>> [image: 20200824_165705.jpg] >>>>>>>> >>>>>>>> On Wed, Aug 26, 2020 at 10:53 AM Richard Stott < >>>>>>> ric at stottarchitecture.com> >>>>>>>> wrote: >>>>>>>> >>>>>>>>> Mark >>>>>>>>> 15 HP is a lot of motor. >>>>>>>>> Can you show us a pic of where its mounted? >>>>>>>>> Any pics of it under the boat? >>>>>>>>> Can you share performance and maneuverability with us? >>>>>>>>> I’m dying to know more about this. >>>>>>>>> A steerable unit is my fantasy but a fixed one might work. >>>>>>>>> Ric >>>>>>>>> sv Dadventure >>>>>>>>> HBNY >>>>>>>>> >>>>>>>>> Richard Stott, AIA, LEED AP >>>>>>>>> www.stottarchitecture.com >>>>>>>>> Office 631-283-1777 >>>>>>>>> Cell 516-965-3164 >>>>>>>>> >>>>>>>>> >>>>>>>>> >>>>>>>>> >>>>>>>>> >>>>>>>>>> On Aug 26, 2020, at 10:43 AM, Mark Whipple < >> mark at whipplefamily.com> >>>>>>>>> wrote: >>>>>>>>>> Hi Richard, >>>>>>>>>> >>>>>>>>>> I purchased my 2000 R22 last year and it came with a 15hp Yamaha >>>>>>>>> saildrive. >>>>>>>>>> I haven't had a chance to use the boat much yet, but it seems like >>>> it >>>>>>>>> will >>>>>>>>>> address many of the issues with an outboard on the transom >>>>>>>>>> (raising/lowering, keeping the drive underwater). >>>>>>>>>> >>>>>>>>>> Unfortunately the company that made this saildrive is essentially >>>> out >>>>>>> of >>>>>>>>>> business. I am concerned about what I'll have to do once this >>>>>> saildrive >>>>>>>>>> needs a part I can't get or needs a costly repair. I'm not sure I >>>>>> like >>>>>>>>> the >>>>>>>>>> alternative solutions that involve a motor on the transom. Maybe I >>>>>> need >>>>>>>>> to >>>>>>>>>> start saving my pennies toward a replacement. Regarding that >> option, >>>>>>> the >>>>>>>>>> saildrives I've seen tend to have larger engine than mine - often >> a >>>>>>>>> diesel. >>>>>>>>>> Mine is essentially a Yamaha (made by Parsun) outboard head so >> it's >>>>>> not >>>>>>>>>> very tall. Maybe I'll be lucky and not have to solve the >> replacement >>>>>>>>>> problem. >>>>>>>>>> >>>>>>>>>> Mark >>>>>>>>>> >>>>>>>>>> -- >>>>>>>>>> Boston, MA >>>>>>>>>> >>>>>>>>>> 2000 R22 *Luna Mia* >>>>>>>>>> 1987 Nimble 30 *For Sale* >>>>>>>>>> 1982 Com-Pac 16 *For Sale* >>>>>>>>>> >>>>>>>>>> On Wed, Aug 26, 2020 at 10:14 AM Richard Stott < >>>>>>>>> ric at stottarchitecture.com> >>>>>>>>>> wrote: >>>>>>>>>> >>>>>>>>>>> Cary >>>>>>>>>>> My ’84 GB mount broke on spring launch the year and my Yamaha 8 >>>> went >>>>>>> in >>>>>>>>>>> the drink. >>>>>>>>>>> I purchased a motor mount from West marine immediately so I could >>>>>>>>> continue >>>>>>>>>>> to use the boat with a spare motor I happened to have on hand. >>>>>>>>>>> Its a stinky smoky ’99 Merc 2 stroke, but it always starts and >> runs >>>>>>> when >>>>>>>>>>> it need it - well almost always. >>>>>>>>>>> I talked it over on the list and discussed with Mike Riter a plan >>>> to >>>>>>>>>>> convert the GB mount to be equipped with a threaded gear (his >>>>>> sketch) >>>>>>> so >>>>>>>>>>> that the mont can be moved with a manual crank or an electric >>>> motor. >>>>>>>>>>> This would be huge advantage over the 6/1 tackle it came equipped >>>>>>> with. >>>>>>>>>>> I’ve been enjoying the boat too much to stop and refine that >> design >>>>>> of >>>>>>>>>>> Mikes - that’s a winter project. >>>>>>>>>>> >>>>>>>>>>> In any case the parallelogram type mount works fairly well, it >> has >>>>>>> pros >>>>>>>>>>> and cons. >>>>>>>>>>> One of the biggest cons is that the moro in the down position is >>>>>>> father >>>>>>>>>>> aft of the transom and will cavitate and lose thrust in larger >>>>>> waves, >>>>>>>>>>> especially with weight on the bow. >>>>>>>>>>> I will like the GB system (modified) over the alternative, but >> the >>>>>>> West >>>>>>>>>>> marine mount was easy to install and serves the immediate need. >>>>>>>>>>> (What I really want is an electric, steerable, remote >> controlled, >>>>>> 20 >>>>>>> hp >>>>>>>>>>> sail drive mounted right behind the keel trunk.) >>>>>>>>>>> It’s doable for approximately one tone of money. >>>>>>>>>>> >>>>>>>>>>> One way I use the boat is unusual. >>>>>>>>>>> I moore my boat 50 yards off shore. >>>>>>>>>>> I use a stand-up paddle board for a tender because it's light and >>>>>> easy >>>>>>>>> to >>>>>>>>>>> cary to the shore. >>>>>>>>>>> I then use the motor only, with the rudder up, to back the boat >> on >>>>>> to >>>>>>>>> the >>>>>>>>>>> beach to pick up provisions and of course my wife, who is not >> one >>>>>> to >>>>>>>>>>> paddle out to the boat. >>>>>>>>>>> Depending on the tide and the slope of the beach, I can sometimes >>>>>> put >>>>>>>>> the >>>>>>>>>>> stern right on the beach. >>>>>>>>>>> An opening in the stern rail, like the more modern R22s would be >> a >>>>>>> huge >>>>>>>>>>> asset for picking up passengers from the beach. (next year) >>>>>>>>>>> Ric >>>>>>>>>>> sv Dadventure >>>>>>>>>>> stay tuned for ‘motor mount mod’ updates >>>>>>>>>>> >>>>>>>>>>> >>>>>>>>>>> >>>>>>>>>>> Richard Stott, AIA, LEED AP >>>>>>>>>>> www.stottarchitecture.com <http://www.stottarchitecture.com/> >>>>>>>>>>> Office 631-283-1777 >>>>>>>>>>> Cell 516-965-3164 >>>>>>>>>>> >>>>>>>>>>> >>>>>>>>>>> >>>>>>>>>>> >>>>>>>>>>> >>>>>>>>>>>> On Aug 26, 2020, at 9:19 AM, Cary Tolbert < >> retiredtoby at gmail.com> >>>>>>>>> wrote: >>>>>>>>>>>> Preview attachment 20200825_174517.jpg >>>>>>>>>>>> 20200825_174517.jpg >>>>>>>>>>>> 4 MB >>>>>>>>>>>> < >> https://mail.google.com/mail/u/0?ui=2&ik=be1ab8c6c5&attid=0.1&permmsgid=msg-a:r-7374969717110164997&th=1742adb6a4937cb8&view=att&disp=safe&realattid=1742adb12d8c3f23bf81 >>>>>>>>>>>> Once >>>>>>>>>>>> again HELP. Wed. the 25th I was motoring from my slip out on to >>>> the >>>>>>>>> lake >>>>>>>>>>>> and kerplunk. The motor raising part of the boat fell off with >> the >>>>>>>>> motor >>>>>>>>>>>> attached and still running. I also had it attached with a s/s >>>>>> chain. >>>>>>>>>>> Lucky >>>>>>>>>>>> or not.? ? ? Stan no longer makes the parts for an 86. He said >> he >>>>>> has >>>>>>>>>>> long >>>>>>>>>>>> moved to newer and hopefully better designs. It seems the >>>> starboard >>>>>>>>>>>> material used to let the motor slide in the rails failed. My >>>>>> question >>>>>>>>> is >>>>>>>>>>>> should I attempt to repair with parts of better materials or >> buy a >>>>>>>>>>>> gerneric system for raising and lowering one's motor . Say >>>>>> something >>>>>>>>>>> that >>>>>>>>>>>> would fit a Catalina 22? Looking for advice from the centuries >> of >>>>>>>>>>>> experience on the list >>>>>>>>>>>> Cary Tolbert S/V Whisper '86 >>>>>>>>>>>> Radford, VA >>>>>>>>>> -- >>>>>>>>>> Boston, MA >>>>>>>>>> >>>>>>>>>> 2000 R22 *Luna Mia* >>>>>>>>>> 1986 Nimble 30 *For Sale* >>>>>>>>>> 1982 Com-Pac 16 *For Sale* >>>>>>>> -------------- next part -------------- >>>>>>>> A non-text attachment was scrubbed... >>>>>>>> Name: 20200824_165705.jpg >>>>>>>> Type: image/jpeg >>>>>>>> Size: 652767 bytes >>>>>>>> Desc: not available >>>>>>>> URL: < >> http://rhodes22.org/pipermail/rhodes22-list/attachments/20200826/730b3b80/attachment.jpg >>>>>>>> -------------- next part -------------- >>>>>>>> A non-text attachment was scrubbed... >>>>>>>> Name: Rhodes 22 MA CL 03.jpg >>>>>>>> Type: image/jpeg >>>>>>>> Size: 61722 bytes >>>>>>>> Desc: not available >>>>>>>> URL: < >> http://rhodes22.org/pipermail/rhodes22-list/attachments/20200826/730b3b80/attachment-0001.jpg >>>>>>>> -------------- next part -------------- >>>>>>>> A non-text attachment was scrubbed... >>>>>>>> Name: Rhodes 22 MA CL 04.jpg >>>>>>>> Type: image/jpeg >>>>>>>> Size: 79585 bytes >>>>>>>> Desc: not available >>>>>>>> URL: < >> http://rhodes22.org/pipermail/rhodes22-list/attachments/20200826/730b3b80/attachment-0002.jpg >>>>>>>> -------------- next part -------------- >>>>>>>> A non-text attachment was scrubbed... >>>>>>>> Name: Rhodes 22 MA CL 08.jpg >>>>>>>> Type: image/jpeg >>>>>>>> Size: 200670 bytes >>>>>>>> Desc: not available >>>>>>>> URL: < >> http://rhodes22.org/pipermail/rhodes22-list/attachments/20200826/730b3b80/attachment-0003.jpg >>
To use your email application to send a messsage to the webmaster rather than this form, .
Your post is being sent... 