The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Mike Riter



Split Ring Alternative?

2020-08-30; 22:53:19 EDT

Member Since

2018-03-19

Posts: 105

Tom, I trailer sail about twice a month on average and set up/take down
every time. I’ve got the routine down to 45 min from arrival at the ramp to
splash. Like you, I’m all about more efficient ways (without sacrificing
safety) to set up and take down.

I’m using 1/4”x 3/4” ball lock quick pins in all 4 short stays. On the
outer stays and forestay I still use the split ring clips, but I bent 3/8”
of the inner part of the ring nearly straight with a pair of pliers so it’s
much easier to start. I tensioned all my stays properly a year ago then
marked all the turnbuckles with black permanent marker. By doing this I can
quickly get all the stays close to the proper tension by turning them until
they touch the black marks. A quick pull on the stays once everything is
rigged lets me adjust everything quickly.  The Velcro wrapped pins work
great, but they take time to put on and take off. I use SS Cotter pins, one
in each turnbuckle and I’ve never had a problem with one walking.

Once the mast is down I coil all the forward lines then shove them into a
stuff sack (like the ones used for camping). This keeps them together and
out of the sun. It’s quick and only requires one tie to hold all the
forward lines. I keep the furling line for the head sail rigged all the
time. I tie the end off on the hand rail to make sure it’s secured against
the wind when trailering.

There are a few more things, but that’s a good bit of it.

Mike Riter
SV EmmaB

See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting