The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Cary Tolbert



motor broke away

2020-09-01; 21:14:35 EDT

Member Since

2012-07-26

Posts: 198

Ric, Stan advised me to replace my old rails made from starboard with
aluminium. I took the old pieces to a machine shop and had them replicated.
Do you remember what material the STOP was made of? This was lost when the
motor came loose. It appears that the STOP fell out and allowed the pieces
that follow the track
to slip out. There were twisted bolts and one sheared bolt. They look to be
about 1/4 inch stainless steel. Stainless is a bear to drill or saw.
Rightly or wrongly I though the Stainless
bolts were much stronger. The newer aluminium rails are fine with no
damage. The 4 ear pieces that slide in the track are made from 5/8
starboard. Some were in good shape but two were eaten out through the edge
of the piece.. Rumer had it (from the previous owner) that the boat was
recycled in the late 90s. What are the chances that only two of the ears
were replaced at that time. The two failed pieces were in much more
deteriorated and worn condition than the other two. But I ramble. The stop
is my next concern. Any suggestions on replacement materials. All Rhodies
are invited to give their thoughts and experiences.
Thanks
Cary Tolbert
S/V Whisper '86

See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting