The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Peter Nyberg



Trailer Bunk pre-stretching

2020-09-03; 11:54:07 EDT

Member Since

2016-04-14

Posts: 711

As I recall, Roger does not have an ‘official’ Rhodes 22 Triad trailer.  My 2016 Triad only has two supports per side for the bunks.  The places where the bunks attach to the trailer are slotted.  My approach to replacing the bunks would be to place the bolds so they are near the far end of the slots, leave the nuts loose, put the boat on the trailer, then tighten the nuts.

I’ve never had an instance where the keel sat on top of the keel boards.  I doubt taking a corner off the boards would do much good.  The keel boards are meant to guide the boat onto the trailer.  If the keel is above the keel boards during recovery, they can’t do their job.  I suspect you may be putting the trailer deeper in the water than is optimal.  The guys at GBI told me that the trailer should be backed down the ramp until the forward end of the bunks are at water level.  (Or, maybe you’re dealing with a VERY steep ramp.)

Peter Nyberg
Coventry, CT
s/v Silverheels (1988/2016)


See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting