The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Stan Spitzer



Converting Electric Winch Motor Lift to a Manual System

2020-09-08; 10:06:21 EDT

Member Since

2019-04-30

Posts: 151

thanks Roger, Peter please note,

We did *not* build the manual motor mount to tilt for the vector change 
reasons Roger covered earlier.  The effort needed to raise up to 9.9  4 
strokes OBs was and is, very reasonable.

To maintain our "proclivity for constant improvement" we did also build 
a tall manual version where tilting a standard 20" long shaft is not 
necessary.

See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting