The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Graham Stewart



Survey

2020-09-11; 10:06:01 EDT

Member Since

2005-04-29

Posts: 814

Ric:

HP = 7.5 hp Johnson 1981
Shaft = 25"
Motor mount = standards manual motor mount - probably original. 

Picture attached from the days of beginning restoration when the boat was very unhappy with me.

Note:  This very simple arrangement appeals to me all the more as I read the seemingly endless posts from those with problems with their motor lift systems. 7.5 Hp seems quite adequate to me except dead  up wind in very high winds. It is also a moderate weight compared to 10 hp 4 stroke motors. I just tilt my motor when sailing and only raise it if I am heeling severely or for long sails. Even so, raising it is not particularly difficult with my  spring loaded motor mount. I am not convinced that the complexity, weight and, frankly, ugliness of the power lift system offsets any advantages it offers. I might feel differently if I actually had the rig to test or needed a much heavier motor. 

Graham Stewart
Agile, Rodes 22, 1976
Kingston Ontario



Agile  stern profile Aug 2009 (4).jpg
See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting