The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Chris Geankoplis



Laz Project Part Duex

2020-09-21; 18:34:40 EDT

Member Since

2004-04-05

Posts: 2060

One of the reasons that I made the anchor holder in the Laz was to avoid
the anchor or chain from sliding to port and shorting out the terminal
block mounted on the hull lifting tube.  This block is associated with the
electric lift system, so if you have a power lift system you might have the
same problem.  With the fuel line passing quite near the terminals, there
is a potential for an insurance claim (grin).  Attached is a PDF with a
short explanation and some pictures illustrating the project.  Hope this
helps someone avoid fireworks in the laz.

Chris Geankoplis
Enosis

Making a Protective Cover for the Motor Lift Terminal Block in the Laz.pdf
See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting