On Thu, Oct 1, 2020 at 4:29 PM Ken Simolo <kensimolo at gmail.com> wrote:
> For shroud covers, I used the 1/4” PVC tubing used for RO systems and sold
> in hardware stores etc. Our hull has blue bottom paint so I used blue PVC
> tubing. In order to make the installation easy, I made a simple jig - I
> took two small pieces of 2 x 4 and screwed their two flat faces together.
> Then I drilled a slightly oversized hole crosswise in the seam where the
> blocks of wood meet. Loosened the screws and slipped a utility blade
> between them near the back edge of the drilled hole with the sharp point
> sticking half way down the hole and the sharp edge facing the front. The
> first couple of inches along the length of the hole just serve as an
> alignment for the tubing. Then just start the tubing into the hole and
> pull on the split tubing as it comes out. Harder to describe abd took
> longer to write this than to do actually do it. To install, I just pried
> open a split end, pushed it up the shroud a little bit, wrapped in blue
> electrical tape to keep the tubing closed, then pushed more on until the
> tubing reached the spreaders. I know I taped the ends but I believe I
> taped it every so often as well. It worled real well and I have received
> many comments about how nice it looks.
>> Ken
>
×
Message to Webmaster:
To use your email application to send a messsage to the webmaster rather than this form,
.