The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Ric Stott



removing tabernacle

2020-10-27; 11:05:17 EDT

Member Since

2013-07-01

Posts: 436

Well - with this library of knowledge, there are lots of scientific solutions to consider - If the hammer doesn’t work.
Can’t wait to find out what happens in the next chapter. 
Ric Dadventure 
PS I hauled Dadventure yesterday evening for the 2nd time on my rebuilt trailer.
I’ve always had a commercial guy for launch and retrial who would  pick it up and deliver it back to my driveway. 
I used the crane set-up that I got for free from Ted DeSantis, near Cape May, NJ a few weeks ago. (Thanks Ted) 
I had to rebuild the deck connector, but the system worked great.  
Went smooth and easy except I didn’t get enough weight forward and the tongue was ‘light’. 
Since I only had a mile to drive,  I didn’t need to re-launch like I did last year when I poked the Center Board through the CB CAP because it was not locked in its cam-cleat when I re-lauched.
That - was a tough, expensive and time consuming lesson. 
 
Richard Stott, AIA, LEED AP 
www.stottarchitecture.com
Office	631-283-1777
Cell		516-965-3164 





See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting